jjames888 (OP)
Newbie
Offline
Activity: 43
Merit: 0
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
February 20, 2012, 09:01:18 PM Last edit: November 23, 2014, 09:55:38 PM by jjames888 |
|
.
|
|
|
|
jake262144
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
February 21, 2012, 12:04:12 AM |
|
Did you unlock by reflashing with a 6970 bios?
The 6970 cards use higher-grade memory chips than 6950, thus a bios flash would set higher memory voltages and clocks than the 6950 memory can handle. This approach is widely known to be potentially lethal to the card, that's why alternative means of unlocking were devised (e.g. the RBE method). Once the damage is done, nothing short of replacing the failed memory chips can help.
Mining uses next to no memory at all, therefore as long as the physically first memory chip on the card is operational the card will work fine.
Also, remember never to use high overclock settings used for mining for playing games - games use other areas of the chip than only the stream processors which may not like the insanely high clocks.
|
|
|
|
jake262144
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
February 21, 2012, 12:41:39 AM |
|
Thank you for the response. The bios were 6950 bios but are TW2 6950 bios.
Just run GPUz and check the clocks and voltages. Post a screenshot here if you're unsure what to look for.
|
|
|
|
jake262144
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
February 21, 2012, 01:37:54 AM |
|
The bounty be damned, I find it more interesting whether the malfunction was caused by the bios flash or mining.
I never damaged any of my cards but there have been failures aplenty reported in the forums. One user reported 10 out of 10 failed GPUs after 6 months of mining - surely, he must have done something wrong.
Your cards seem to have had an easy life being undervolted and only slightly overclocked.
Since you mention this was a specially crafted BIOS, the failure is either mining-related or just random.
|
|
|
|
bangra
Newbie
Offline
Activity: 43
Merit: 0
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
February 22, 2012, 12:01:41 PM |
|
Have you tried it in a different Motherboard? also you could try cooking the card in the oven for a few minutes
|
|
|
|
malevolent
can into space
Legendary
Offline
Activity: 3472
Merit: 1722
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
February 24, 2012, 06:59:02 PM |
|
Its not the motherboard. I know that for sure. The oven method I have not tried. I am not experienced with that. I've read about people doing it for different things. It creates a "re-flow" of something so that the electrical condition is better. I'll google it but please tell me more about this and what it might fix Edit: I did google it. I am considering this. Bake it at 385 for 8 minutes maybe longer. I didn't see a consensus online but 8-10 minutes seemed to be it. I might just try this. [/quote] Remember this is only temporary.
|
Signature space available for rent.
|
|
|
ssateneth
Legendary
Offline
Activity: 1344
Merit: 1004
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
February 27, 2012, 12:30:05 AM |
|
Its not the motherboard. I know that for sure. The oven method I have not tried. I am not experienced with that. I've read about people doing it for different things. It creates a "re-flow" of something so that the electrical condition is better. I'll google it but please tell me more about this and what it might fix Edit: I did google it. I am considering this. Bake it at 385 for 8 minutes maybe longer. I didn't see a consensus online but 8-10 minutes seemed to be it. I might just try this. Remember this is only temporary. [/quote] Reflow means melting the joints that join whatever is on the PCB to the PCB itself. In many heat/cool routines, the joints can become stressed and crack. Liquifying, or reflowing, them removes these cracks and completes the circuit.
|
|
|
|
malevolent
can into space
Legendary
Offline
Activity: 3472
Merit: 1722
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
February 27, 2012, 12:10:49 PM |
|
Reflow means melting the joints that join whatever is on the PCB to the PCB itself. In many heat/cool routines, the joints can become stressed and crack. Liquifying, or reflowing, them removes these cracks and completes the circuit.
Yes, but it is only a matter of time before the problem returns and you have to do it again, next time it won't that long. It can work for a few weeks or a few months.
|
Signature space available for rent.
|
|
|
scifimike12
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
February 28, 2012, 02:28:54 AM |
|
I don't know, I would rather RMA it before trying to "bake" it. MSI warranties through the serial number.
|
|
|
|
crosby
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
February 29, 2012, 02:49:13 AM |
|
I don't know, I would rather RMA it before trying to "bake" it. MSI warranties through the serial number.
Not at option. I'm baking it tonight also Edit: Baked. I will post results later Edit: Ya didn't work Now that the card is really "baked", does it still mine ? or is it completely dried toast now
|
Get your BTC and LTC at www.betcoinpartners.com/c/2/374 with FREEROLLS + Daily & Weekly Bonuses + Satellites + ON DEMAND tournaments + Instant Deposit + Instant Withdrawals + RING games + GTD Tournament + On Demand Satellite, + LIVE DEALER CASINO + SPORTSBOOK + 100% WELCOME BONUS www.betcoinpartners.com/c/2/374 150 btc ($100,000) gtd monthly, 75 btc ($50,000) gtd weekly and 10 BIG daily gtd ranging 0.5 btc to up to 20 btc
|
|
|
BCMan
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
February 29, 2012, 06:58:16 AM |
|
But it shows desktop, can you play videos with it, etc? Tried to run 3dmark03? Tried to run older games, which not require shader support, Unreal Tournament, Mafia for example or some 2d games like Fallout, Baldurs Gate?
|
|
|
|
BCMan
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
February 29, 2012, 02:46:31 PM Last edit: February 29, 2012, 03:05:45 PM by BCMan |
|
But it shows desktop, can you play videos with it, etc? Tried to run 3dmark03? Tried to run older games, which not require shader support, Unreal Tournament, Mafia for example or some 2d games like Fallout, Baldurs Gate?
It doesnt even like to show desktop always Well yeah, then gpu chip is dying/almost dead. Desktop requires almost zero load from card. But shader units are still ok it seems - you still can mine with it with same performance. So, most probably its not mining killed the card. Well, its a lesson - never try to unlock shaders, never run it with custom "homebrewed" bios and mine with underclocked mem/max possible undervolting.
|
|
|
|
malevolent
can into space
Legendary
Offline
Activity: 3472
Merit: 1722
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
February 29, 2012, 04:15:58 PM |
|
Well yeah, then gpu chip is dying/almost dead. Desktop requires almost zero load from card. But shader units are still ok it seems - you still can mine with it with same performance. So, most probably its not mining killed the card. Well, its a lesson - never try to unlock shaders, never run it with custom "homebrewed" bios and mine with underclocked mem/max possible undervolting.
unlocking shaders in a 6950 is ok, only running a 6970 bios isn't
|
Signature space available for rent.
|
|
|
malevolent
can into space
Legendary
Offline
Activity: 3472
Merit: 1722
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
February 29, 2012, 11:58:31 PM |
|
The shaders were unlocked and not 6970 bios if that was implied anywhere. They were homebrewed bios but a couple dozen people at least have used them fine for as long as I have. The card was originally not the best card. So I am pretty sure it was the combination of bad card unlocked shaders and mining 24/7. Very few problems are so simple as to be 1 cause.
Do you know what was changed exactly in that bios? Also what were the VRM temperatures?
|
Signature space available for rent.
|
|
|
sveetsnelda
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
March 03, 2012, 08:55:46 AM |
|
Does this card actually crash the driver when trying to run games, or does it just always have visual artifacts?
|
14u2rp4AqFtN5jkwK944nn741FnfF714m7
|
|
|
sveetsnelda
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
March 03, 2012, 07:31:59 PM |
|
I showed that in the msi afterburner graph in the first post.
Not quite. That's why I asked. You said something about raising voltage causing artifacts when you first got the card. I was double checking to see if it was stable other than the artifacts. I think it was just assumed by others.
|
14u2rp4AqFtN5jkwK944nn741FnfF714m7
|
|
|
jojo69
Legendary
Offline
Activity: 3248
Merit: 4463
diamond-handed zealot
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
March 03, 2012, 08:23:50 PM |
|
Reflow means melting the joints that join whatever is on the PCB to the PCB itself. In many heat/cool routines, the joints can become stressed and crack. Liquifying, or reflowing, them removes these cracks and completes the circuit.
Yes, but it is only a matter of time before the problem returns and you have to do it again, next time it won't that long. It can work for a few weeks or a few months. I have had baked cards run for years, it is a combination of random and the number of hot cold cycles, best bet IMO is to run your stuff 24-7-365
|
This is not some pseudoeconomic post-modern Libertarian cult, it's an un-led, crowd-sourced mega startup organized around mutual self-interest where problems, whether of the theoretical or purely practical variety, are treated as temporary and, ultimately, solvable. Censorship of e-gold was easy. Censorship of Bitcoin will be… entertaining.
|
|
|
malevolent
can into space
Legendary
Offline
Activity: 3472
Merit: 1722
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
March 03, 2012, 09:37:32 PM |
|
I have had baked cards run for years, it is a combination of random and the number of hot cold cycles, best bet IMO is to run your stuff 24-7-365
Well I doubt it would last that long with GF8800 cards ;-) Also with those that are lead-free.
|
Signature space available for rent.
|
|
|
jojo69
Legendary
Offline
Activity: 3248
Merit: 4463
diamond-handed zealot
|
![](https://bitcointalk.org/Themes/custom1/images/post/xx.gif) |
March 27, 2012, 03:54:36 PM |
|
Well, its a lesson - never try to unlock shaders
lol...fail 2x 6950 unlocked here have run 900MHz-400Mh/s for over a year 24/7 so yeah...whatever
|
This is not some pseudoeconomic post-modern Libertarian cult, it's an un-led, crowd-sourced mega startup organized around mutual self-interest where problems, whether of the theoretical or purely practical variety, are treated as temporary and, ultimately, solvable. Censorship of e-gold was easy. Censorship of Bitcoin will be… entertaining.
|
|
|
|