Technobit Avalon Gen2 Power ??

[kmaikaza]

  Helo Wourld

  I need help i have this board

  http://technobit.eu/index.php?id_category=12&controller=category&id_lang=1

  Do i need to have 5 v and 12v conectred or only 12v and usb cable

  I am not runing in from a pc but from a Hp mini laptop to save power only 30W and will power the miner from a old laptop power suply 12W@10A

[marto74]

 Helo Wourld

  I need help i have this board

  http://technobit.eu/index.php?id_category=12&controller=category&id_lang=1

  Do i need to have 5 v and 12v conectred or only 12v and usb cable

  I am not runing in from a pc but from a Hp mini laptop to save power only 30W and will power the miner from a old laptop power suply 12W@10A

You need only 12 v power and USB for data.
12 v is on molex or wire terminal.
10 A is on the edge

[kmaikaza]

TXN

it does seams to be alive but now i am detecting it but not hashing look at print scr if you have time

http://s28.postimg.org/nfr7k0tvt/bjelo.jpg

http://s23.postimg.org/p3fuenafb/crno.jpg

[Zich]

Set pool to : http://localhost:8332

Set frequency to : 1500

Set voltage to : 1100

uncheck: test only



But please consider to use TPLINK TL-MR3020 as host. Cheap & small power consumption.

[kmaikaza]

ok i did that it power on and everything but i get eror that authorization not ok and i did try more pools .

http://s27.postimg.org/drufssiu7/asadaada.jpg

what now

And thanks for all your help

[Zich]

That's seem normal message. You are not using xxx as password right?
Please post the HEXMINER screen shot.

[kmaikaza]

http://s28.postimg.org/z09g8zf49/aaa.jpg

And i have red and green led on no flashing , the 12v rail is active i did probe with multimeter on the board and i get 12 v on some areas but the fan conector i am geting 0v.

and when i connect the 12v and ted power on i get 0.05A standby and does not go up wen i star the miner

[marto74]

try to remove the Diode like part on the power connector, or just send it for RMA

[kmaikaza]

It is all weird  i connected 5v rail and now my fan works .
All the chips have 3.29v supply on one of the pins.
And next to the Motorola micro controller i am geting twice 12.12v psu voltage and 8.6 and 8.9

And i ship it over your site , and i dont have to send the cooler just the pcb to save on shipping.

[marto74]

ok