Help: AntMiner S1!

[sapta]

-sorry, bad english-

My S1 on the right one is hotter than the left one. Any correction for my S1's position, guys? Thanks!



===

[1715222800]

1715222800

[Hektur]

I'd suggest moving them a little bit farther away from the power supply so that it wasn't pulling in the heated exhaust from it.  I'd also suggest putting a 2nd fan on both units for a push-pull configuration to help pull heat from the units.  Also maybe add a fan to push cooler air into or toward the units that is unless you have an air conditioned room to move them into.

[sapta]

I'd suggest moving them a little bit farther away from the power supply so that it wasn't pulling in the heated exhaust from it.  I'd also suggest putting a 2nd fan on both units for a push-pull configuration to help pull heat from the units.  Also maybe add a fan to push cooler air into or toward the units that is unless you have an air conditioned room to move them into.

Actually, the blue fans are pulling the heat. Hmm, so then I need to hide the PSU somewhere farther, right? Great, thanks!

[Hektur]

Ok, I can see the plug on one unit showing that you already have 2 fans on each unit.  Pull them a bit further from against the wall to allow them to pull more air through the units.

[xjack]

If it were me...

- I'd get those PSU's turned so the fans are unobstructed - there's a high likelyhood the hot air blowing off that PSU is causing your temp difference.  There's also a high likelyhood the one on the right will fail first, since it can't exhaust properly.

- I wouldn't worry about 1 degree difference as long as it was hashing the correct speed.


My 3 ants all run at different temps.  For example, right now they are at 51.5/50/51

[nwfella]

Also suspect the PSU is resulting in higher temperature for that unit.