Well I sold this on ebay like a fool. Then after the buyer received it he couldn't get it working and "then" notice burn marks.
Ebay sided with the buyer and I was out all the money. I got the unit back. I looked at it and noticed only one blade had burn marks.
I put the controller card on the other blade and attempted to use one blade. Low and behold it didn't have the default network settings.
So I checked to see if it magically reverted back to my settings when I had it. Nope. I fired up tcpdump and found it on a IP that the buyer set it too. root didn't work for the password luckily the word antminer did. I am not even sure if this is the same antminer.
So the one blade is hashing just fine now
Chain# ASIC# Frequency Fan Temp ASIC status
1 32 393 1860 42 oooooooo oooooooo oooooooo oooooooo
I haven't attempted to power on the blade. Mostly because I have too many sensitive smoke detectors and management always calls when they go off and I rather not deal with that. The real question is if I can disable the burned out section of the blade and use the rest of the chips. I remember on the asicminer BE 10gh blades you were able to disable sections. Anyways sorry for the long post. So I am just wondering if it is possible to disable the bad section or if I should just toss thing out. This isn't important as I have much better mining gear but I guess I need something else to do. No worries if it can't be fixed.
