S1 Installs Going Like Silk... then?

[pokeyjones]

Adding miners, navigating to them by their IP, login, configure, assign a new IP for that miner... NEXT!

Three miners without a hitch. I have added a 10/100 switch and while I can access the miners configured yesterday through it, I cannot reach any of the new batch of three. Basically I need, 1 by 1 through the switch, to login to each miner / configure / change IP.

With these new machines I'm completely unable to access them. Looking for some help here before I unplug everything and start from scratch. Sounds like a good project for tomorrow?

SO MUCH INFO HERE! It is daunting finding the right info. So, how can I directly login to these machines, or find their IPs on my network? I have  FiOS router so let's leave that out of it if possible.

thanks so much!

[Prelude]

If you have an android phone check out an app called "Fing". I'm sure there's an ios equivalent.

[generalt]

Try a factory reset.

[kabopar]

Make sure that none of the existing S1's is still on the factory default 192.168.1.99.  Note that you'll need to power the new S1's one at a time and change their fixed IP addresses (if you turn on more than 1, there might be an IP address clash).  As suggested doing a factory reset is a good idea.

Cheers