SP20 Help!!!! CGMiner won't start!!!

[bgibso01]

Just like the title.  I've tried factory reset, re entering the pool info, etc. No go.  Would like to have this running before I head out tonight.

[Dr Charles]

Have you looked at the "ASIC Stats" page to see if there are any errors coming up or anything unsual?

[bgibso01]

Have you looked at the "ASIC Stats" page to see if there are any errors coming up or anything unsual?

Yes, no adapter!

[bgibso01]

It looks like it loaded the Dawson SP10 firmware because that's what it shows on the main screen now.

[bgibso01]

After a recovery, everything is back in order.  Looks like a PSU problem of the paper clip method not secure enough to keep the PSU stable.

[MrTeal]

After a recovery, everything is back in order.  Looks like a PSU problem of the paper clip method not secure enough to keep the PSU stable.

That's interesting. Was the unit resetting? The PS_ON signal is just a TTL level, it's weird that if it worked a little but not at high power levels.

[bgibso01]

After a recovery, everything is back in order.  Looks like a PSU problem of the paper clip method not secure enough to keep the PSU stable.

That's interesting. Was the unit resetting? The PS_ON signal is just a TTL level, it's weird that if it worked a little but not at high power levels.

I was using 2 HX850 psus.  I think one of the wires on the 24pin adapter is loose. I even tried one of the antminer switches and that's where it really showed up as the led would come on and then go off with just the slightest movement. I put it on a different psu and it's been rock solid ever since.

Edit:  Yes the unit was probably resetting since it wasn't hashing above 500gh/s.  But by the time I would notice, it wasn't hashing at all.