Adding two Fury miners

[JetMech]

I'm currently running MultiMiner for three Antminer U2s and would like to add two Fury miners (1.3 MH/S ASIC). They aren't being detected when I plug them in to the powered USB hub. What else do I need to do to get them going besides setting up the scrypt pool?

Thanks.

[nwoolls]

I'm currently running MultiMiner for three Antminer U2s and would like to add two Fury miners (1.3 MH/S ASIC). They aren't being detected when I plug them in to the powered USB hub. What else do I need to do to get them going besides setting up the scrypt pool?

Thanks.

Check both the Getting Started guide along with the required drivers for various hardware (keep in mind GAW is rebranding ZeusMiner hardware):

https://github.com/nwoolls/MultiMiner/wiki/Getting-Started#getting-started
https://github.com/nwoolls/MultiMiner/wiki/Drivers#drivers

There's also the official thread here for discussion and feedback:

http://thread.multiminerapp.com

[JetMech]

Will I have to make any changes to BFGMiner?

[nwoolls]

Will I have to make any changes to BFGMiner?

No as long as you have the correct drivers installed and Scan Hardware they should show up. From there you can assign a Scrypt coin / pool and start mining.

[JetMech]

I have Windows and the latest UART driver installed on all the miners/com ports. (Or do I need the OS / Custom CDC Driver for the Fury?)

Also, the Scan Hardware button is greyed out.

[JetMech]

Just tried a reboot without any luck...just to see if it'd help.