Running Bi-Fury 4gh/s on Raspberry PI with Minepeon

[kieron]

HI, I have set up mine peon on my raspberry pi and set all the pools and logged into the pi on my computer browser, set up the pools I want and connected in the two miners I have got. My problem is I can see the lights are green on the miners but when I am on the main page of the overview of how minepeon is doing, the hashrate displays only one line for the two of them and always says 0 mh/s. I am not very techsavvy with this area of mining and new to all of this. Thanks if you can help me out here.

[1715439248]

1715439248

[1715439248]

1715439248

[vm1990]

from what iv found out so far minepeon sucks for bi*fury gear if you log in via ssh and press "a" you will see cgminer... iv given up with minepeon the last update was a long time ago now and the pi quite frankly is a peice of crap for anything other than looking at. i was so looking forward to getting everything working on it but the lack of both updates and proper drivers simply causes me to much trouble
n
untill someone comes out with a proper update i will neither support or recommend minepeon works great for anything with 1 mining chip its a good job ot was free otherwise someone would be getting punched...
yes im angry and yes im going back to eco boards running Windows

my results from testing are
bfgminer gives loads of HWerrors
cgminer works but crashes after a while stating some sort of kernel error (tested everything from psu to cables it can only be  peon is incapable of running the miners for long)

[vm1990]

i got mine working in the end had to use bfgminer and after a while it does show up the web interface takes a good few minutes to update