Hey guys!!
I recently underclocked my antminer S1 (pencil mod) for various reasons and I am getting some unexpected results. The miner is running around 100 GH/S with an error rate above 20%
and I am not quite sure why. I figured I would be able to run this bad boy around 140 GH/S with an acceptable error rate and I still believe it is very much possible(I must be overlooking something). Any and all suggestions are welcomed, below are the settings and adjustments I made.
Board One:
R3: 2.96 R66: 2.89 R38:2.95 R52: 2.93
Board Two:
R3: 3.01 R66: 2.91 R38:2.95 R52: 2.99
option 'freq_value' '0A81' #275M
option 'chip_freq' '275'
option 'timeout' '45'