Let me rephrase...
If a C1 is 2 x S3's....
I already own a C1 but i also own 2 x S3's.
I wish to convert the 2 x S3's to make it into a C1, If this is even possible??
It would mean i would be able to run 2 S3's off 1 power supply like a C1 not to mention i would lose the noise of 2 S3's..
Is there kit out the available to ,ake this happen??
Yes, it's possible. A C1 is 2 x S3. They even sell the waterblocks individually. The problem is there is not a kit with all the parts, you would need to figure out how to do it yourself. The big problem is getting the small parts you need. The controller card is the same, but I believe 2 of the cables need to be longer than what comes in the S3 (that might not even be true if you can fit them in a S3 case, but the controller card would need to be relocated higher to allow the power cable to one of the boards if you are going to use both connectors on the two internal boards, which may be easy). Also, getting the screws and springs. Other than that and some simple modding of the S3 case by drilling some screw holes on the bottom and front, if I'm not forgetting anything, you can do exactly what you're asking.
