• Order ID: 0012017081103458
• Date: 2018-07-11 04:04:02
• Total: 0.44003916 BTC
• Payment method: Bitcoin Payment
 
• Order ID: 0012017081107067
• Date: 2017-08-11 05:09:15
• Total: 0.03935787 BTC
• Payment method: Bitcoin Payment

I have delivered the the antminer on 22/06/2018  from antminer-store.com

Hi,
I`ve just run into innosilicons offer, A9 Zmaster 1+1 for free, immediate shipping.

https://innosiliconshop.com/innosilicon-a9-zmaster-with-psu-innosilicon

They "helpdesk" claims that BOTH miners will be shipped immediately after payment, although I`m still unsure about this.
Is this even their real site or some kind of a scam?

Can someone confirm this?

Thanks.

i was the one how bought the asgardminer from ebay, They canseld the order and told mee they only sell this miners from the new webbshop. i still waiting for the miner . bought one 27 of june.  still waiting and no confirmation on the order.
Has any one bought any miners from asgard or is it only mee how is stupid to buy from asssgard ??

Expensive stuff? Software asicboost supported? What return on investment does it have? Wrote that 2 months, but hard to believe.

So far I've had 6/60 PSUs fail on me. That's a 10% failure rate, and something seems up.

When I get back to work on Monday, I'm going to crack it open and see if I can find any failed components, but has anyone else experienced failures with these PSUs? They are the ones that came bundled with the A4+ ASICs.

Thanks! I'll report my findings here after I trouble shoot them.

Yes, Thanks for posting.... they suck. I will never order again! I am at more like 20% fail and they keep failing every day. Most fail within 10 minutes but now it seems every day another one goes down that has been running 24 hrs + Total nightmare! And then the cheap bastards only offered a $60 coupon towards future purchase... and say to buy local replacement...  good bitmain +++ on ebay is over $180 on a good day. WTF, I have to spend $172,000 more to get the PSU credit. I am usually not this upset about company deficiency but Innosilicon is a shit company that charges too much for a shit product. They have shit customer service and are the cheapest bastards that their ever was. Send them $180,000 and they do not believe you when you report a few failed PSU. Scum bags!, and I should have known since they are related somehow to the other shit company called AliScamba as it was displayed on their shipping label.
They fail on 110v and they fail on 240v, I am using same outlet that works fine for antminer no problems ever.
It must be one diode that fries but even when you open there is no fuse to replace.
Please post if you find a way to repair. Most make a click sound when turned on after fail.

Sorry about the late reply.

I had two of these failed PSUs, and repaired one this weekend. (The other was used for spare parts.)

The problem is a failed MOSFET on the secondary, which fails short. Thankfully the PSU has short circuit protection, that's why you hear the click. Check the output with a multimeter, you will likely see a shorted output. If so then the fault is most likely one of these MOSFETs.

This can be repaired pretty easily with a hot air rework station, some experience doing these sort of repairs, and some patience as the MOSFETs are pretty solidly soldered to the board and surrounded by large copper planes. An easy way to check to see which MOSFET failed is to probe between the gate and the drain or source (just use a nearby heatsink); the failed MOSFET will show ~4.4ohms lower, as the working units will pass through two 2.2ohm resistors in series, the failed one will be low impedence to the source and drain. I took a working MOSFET from one failed PSU and transplanted it into another, and now I have a working PSU and another PSU for spares.

If you don't want these PSUs and still have them I can buy them, or if you have multiples I can repair them but cannot guarantee how long they will work with the stock MOSFETs, they seem to be trash. I haven't checked for what replacements will work for quality MOSFETs or the cost. Other than the shoddy MOSFETs the PSU is built decently enough.

Hi,

I installed Dollemizer in a T9+. Unfurtenately, it did not work my hashrate is zero. I tried to uninstalled an reinstall Bitmain´s firmware, but the hashrate is still zero, it is not possible to uninstall the software. What can I do the Antminer is new, and I lost the warranty.

Whats the profitability like currently mining ETN since the algo switch?

Why would a new miner cause the price to go up?

Just use some IP Scanner, or look in to the admin panel of your router.
There you will see the IP of your A9, just put that in to the adressbar of your browser.

Then it pops up login panel, there you just put:
Username: Admin
Password: Admin

Then you are in the Panel, there you have to chose your pool and you are up and running!

I work with this Claymore 11.6 and 11.8 no fee miners:
https://github.com/jrnopnop/Ethereum-Claymore-11.6-No-Fee---DevFee-Removed/releases
https://github.com/jrnopnop/Ethereum-Claymore-11.8-No-Fee---DevFee-Removed/releases

two weeks mine at nanopool... 

Rubbish units with high rates of failure. Bought a defective one, sent it for repair, returned faulty AGAIN. Yet Innosilicon refused to bear the shipping cost for their shit servicing. They are having a buy 1 get 1 free yet they can't repair/replace a unit? Think twice before you buy from the most toxic company ever guys.