 Show Posts
|
|
Pages: [1] 2 »
|
|
Nemo a want to say that you are fucking asshole!!!
"4/17/2019 4:15:45 PM","NVIDIA","Veil","16Qf1mEk5x2WjJ1HhfnvPnqQEi2fvCeity","nemo","veil.mine.zergpool.com"
"4/17/2019 4:18:57 PM","NVIDIA","Veil","16Qf1mEk5x2WjJ1HhfnvPnqQEi2fvCeity","nemo","veil.mine.zergpool.com"
"4/17/2019 4:29:00 PM","NVIDIA","Veil","16Qf1mEk5x2WjJ1HhfnvPnqQEi2fvCeity","nemo","veil.mine.zergpool.com"
"4/17/2019 4:37:37 PM","NVIDIA","Veil","16Qf1mEk5x2WjJ1HhfnvPnqQEi2fvCeity","nemo","mine.nlpool.nl"
"4/17/2019 4:42:37 PM","NVIDIA","Geek","16Qf1mEk5x2WjJ1HhfnvPnqQEi2fvCeity","nemo","eu.phi-phi-pool.com"
"4/17/2019 4:45:50 PM","NVIDIA","Veil","16Qf1mEk5x2WjJ1HhfnvPnqQEi2fvCeity","nemo","veil.mine.zergpool.com"
"4/17/2019 4:49:24 PM","NVIDIA","Geek","16Qf1mEk5x2WjJ1HhfnvPnqQEi2fvCeity","nemo","eu.phi-phi-pool.com"
"4/17/2019 4:57:12 PM","NVIDIA","NeoScrypt","16Qf1mEk5x2WjJ1HhfnvPnqQEi2fvCeity","nemo","blockmasters.co"
and i can't stop ur fucking miner to mine for you!!!
|
|
|
|
|
is it difficult to wrtite list of supported algos?
|
|
|
|
still no list with supported algos  |
|
|
|
|
Minerx or MrPlus can you write a list of all supported algos by Nemosminer in readme or on first page?
What about new aslgos eqiuhash on zergpool?
|
|
|
|
|
Please write list of supported algos!!!
|
|
|
|
1. Guys what to do with miners that haven't gathered full speed and become unprofitable, because of wrong speed calculated? 2. If we run some instanses of Nemo hsr miner calculates MHS not from hsr miner, it calculates mhs from another ccminer xevan then write it to prifits and use wrong stats! http://prntscr.com/irls5fi think its a very bad idea to calculate profits from the current hashrates, because its too difficult to get full speed for an defaults intervals, so all calculating becomes wrong |
|
|
|
|
eth-claymore use all gpu instead of listed in config
|
|
|
|
|
How to lower cpu utilization ?
|
|
|
|
|
when Nemos switching in one algo between pools he does not calculating Gainpct and switch same algo between pools very often. Am i right?
and I want to ask Nemo if hi can:
do calculating REAL PROFIT for the time of running Nemosminer.
And make calculations POOL FEES = ((ESTIMATED PROFIT - REAL PROFIT)/ESTIMATED PROFIT)*100
And add support of excavator miner pls...
|
|
|
|
|
when will we have ability to add yiimp based pools to AM?
|
|
|
|
Hi Patrike
please add in your system this wonderful multipool service: d3pool.eu
Its realy good pool with low fees.
Thanks for the suggestion. I will try to find a good solution for supporting yiimp-based pools like this one in general, so any of these pools can be supported. it would be great! So many new good pool yiimp based! |
|
|
|
|
when will be compared reports vs zergpool)?
|
|
|
|
guys any opinion about tribus algo an ahashpoll is it profitable to mine using estimate current price?
Definitely not Actual 24 hr is $2.20/1070ti card Current Estimate is $3.02/1070ti card Right now most profitable is X17 at $4.57/1070ti card (basically XVG VERGE) i wasn't talked about right now...i was talking about at all... many times it becomes most profitable, but when saw earnings u see very low values... that i was talked about and other question everyone has low profits on ahashpoll last week or only me? (-30%) Everyone has seen 30+% lower profits because of falling crypto prices. Estimates are if current value stays the same, but when you have crypto and bitcoin crashing 20-30% daily you will not achieve anywhere close to estimates. I remove Tribus completely, its never been very profitable. thanks a lot! |
|
|
|
guys any opinion about tribus algo an ahashpoll is it profitable to mine using estimate current price?
Definitely not Actual 24 hr is $2.20/1070ti card Current Estimate is $3.02/1070ti card Right now most profitable is X17 at $4.57/1070ti card (basically XVG VERGE) i wasn't talked about right now...i was talking about at all... many times it becomes most profitable, but when saw earnings u see very low values... that i was talked about and other question everyone has low profits on ahashpoll last week or only me? (-30%) |
|
|
|
|
guys any opinion about tribus algo an ahashpoll is it profitable to mine using estimate current price?
|
|
|
|
|
i igree with millsys
I installed new driver version 390. and Nemosminer 2.4 and saw very low profit,
rolling back to 2.3 version but profit is still low, any ideas?
my earnings on ahashpool using Nemosminer was less 30% then usual last week. My rig 8-1070 usually gets 0.0025-0.0035 btc day, now bellow 0.0020
|
|
|
|
Your miner is working fine with my 10 cards rigs (Asrock h110BTC pro, 10x 1070 (or 1070Ti)), no need to add more support for biger rigs imho.  Can you please consider adding an option to regulate % difference of profitability before switching algo? I thought that windows 10 can support only 8 gpu or u are talking about linux version? Anyone knows how many gpu can support asus z270- in windows 10 now it has 8gpu and one free of 2 m.2 socket? |
|
|
|
|
Hi Nemo it seems to me that time of ran miners wrong?
and hsr palgin miner returns wrong result for neoscrypt writes 909,72 MH/s real 9.09 MH/s
|
|
|
|
|
