So we've updated X16R/RavenCoin results and they are still good
We've tested ccminer, t-rex and z-miner. T-rex and z-miner gives similar results about 20 MH/s.

Hi all,



We've just finished first RTX 2070 benchmarks, results are I would say fine, read more here:
https://crypt0.zone/nvidia-rtx-2070-mining-benchmarked

Let us know what do you think and what to test more. We won't be able to test it under windows, sorry.

Sorry for late replay.

Thanks for kind words!

So temps we've got are:


But it was taken about 1 month about when it was full summer here. Now temperatures at gpus are about 10C lower.
About putting this rig on back - I don't need to do it right now since temps at this moment are below 60C.

Yes, with slight modifications you should be able to use it with standard ATX.

@dragonmike thanks!

I don't where you're based but in some countries you could print all those things in ~$50 with recommended PETG, but still I would buy some cheap printer like Anycubic i3 mega

ONDA D1800 is about 10cm narrower so you'll end up with lot of free space but besides that it should fit without any problems.

Hi!

We've wanted to share our project based on 20x20 extrusion profiles + 3d prints: Hackable DIY rig for  Biostar TB250-BTC D+

You need to buy 20x20 extrusions, few screws and nuts for them.

We've been using this project for about 1 month now with 8xRX570 and we're very happy how it's performance.

At link above you'll find tutorial how to build complete frame from scratch

We'll be happy to hear what you think about it!

@adaseb you're right. But if you own 3d printer this is cheapest solution ;-)

I measured it - it's 6.1cm or 2.4 inches high wit standard 80mm fans.

I didn't measure it. Tomorrow I'll be at my mining site and I'll check dimensions