My first interest is for the S3/S5 upgrade board, 2x But POD is likely to go out first, 2x
|
|
|
Only issue is if you turn it off, it wont start hashing cold.
this^^^ were i live it can get to 20* below , i feed my miners filtered air from outside in the winter , if u need to power off and power the miner back on in that kind of temp it usually wont restart. last winter i had to keep a hair dryer in my datacenter for restarting miners when it got cold out , oddly enough the only ones i had issues with were the miners that used the beagle bone controllers , all the s3;s would start right up no matter how cold , for this winter i have restricted the fresh air intakes a bit to keep the miners warmer , and all is good , though our coldest night so far was only 2* as mentioned s7 and s9 miners do not like to run very cold, so if u have those u may have issues,, spondoolies gear absolutely loved the cold , infact im still runing a bunch of sp20 and sp31's, older miners like the s1/s3/s4/s5 walso ran just fine in the very cold temps , with the exception of restart issues on the s4 and s5's , warming up the controllers with a hair dryer on low solved that issues though if they wouldnt boot up on there own i dont expect any issues this year though with the restricted air intakes and the fact i have alot more gear now and it keeps the building decently warm Cold boot is a no go for sure. Pre-heat it in-house to warm up then trow it in the shed. My S9 like to be cooled. It's a batch 10 / 11.8TH Ambient temp outside, -13C last night , is 10 Degrees C in my shed. Very low hardware error and run like a champ at 13.1TH/s
|
|
|
I had prototype something , but didn't finish it. Solution was very simple. A Pi and some arduino controller to toggle On/Off command on ATX P/S. Load Raspberry Pi with TeamViewer https://pages.teamviewer.com/published/raspberrypi/Program serial command to Arduino for On/Off control. Arduino come with USB/Serial FTDI chip. When connected to the Pi, it see it as serial port. I programmed a simple ASCII command for On/Off command. Only problem, is that TeamViewer for Pi change is ID each boot ... that's was stopped me. Total BOM, least than 75$
|
|
|
Still available to manage Canada group buy if need be! Add me to your list.
|
|
|
Maybe interested if the USB adapter were included, but US only.
|
|
|
sound levels
from about four feet.
this is not as quiet as a sidehack modded s7-ln this is not as quiet as an avalon 4.1 that is downvolted and under clocked.
In my friends office it is fine It is definitely quieter then the avalon 721.
Thanks, useful sound classification. I like my S7-LN but I wish it was filled with BM1387 chips
|
|
|
How about noise ? The 721 is probably more quiet -900W- compare to the A6 -1100W- ? I like the S7-LN as home heater, the 721 could be a nice upgrade for same noise and power range. Would be nice to compare it to the R4 too. I think you have one incoming
|
|
|
It would be nice if you use PCI-e connector to replace the DC barrel ( I hate those ) for power connection. It's overkill for a pod, but overkill never fail
|
|
|
Tentative pricing for a Bitfury 16nm pod is around $125. My reseller friends are worried that >$100 is too much for a pod miner. With an estimated stock setting of about 650GH at 75W DC, would folks still buy it? That's priced high even by Avalon721 standards, but it also has better efficiency - and with integrated undervolting, it can get better still.
With those specs, count me in for 2x pods
|
|
|
Bump, getting rid of more stuffs. Omega temperature controller with RTD probe for week-end project
|
|
|
My rig : 6x GTX1060, 1x EVGA G2 1000W, Mobo + SSD I'm in Canada I want to order a GPU frame but, sadly, you don't accept BTC.
|
|
|
Super duper, you had a great deal for sure ... thanks for this smooth transaction
|
|
|
Actively Looking for ( cheap ) S7-LN / Avalon6 and EVGA P/S
|
|
|
Yeap, that's the picture ... don't know why it didn't display on my post ...
You didn't add the tags for the image. Use the code below and it should work (not a sizing issue since MJ got it to work) [img]https://i.imgur.com/SyYOxWz.jpg[/img] I got the proxy error ... I removed it but put it back to be sure. No chance. Thanks anyway. PM answered
|
|
|
Newegg accept bitcoin. You can order from them ,depend on where you live.
|
|
|
Hi community, I'm looking for some S7-LN shipped to Canada. I purchased 3x units from Allinvain 2 months ago. https://bitcointalk.org/index.php?topic=1606950.20Really nice heater, looking for more. I will purchase via Escrow , mostly Phil or OgNasty. I have the budget for 1x miner ATM, I will buy more, in time, if price is right. No crazy high price, looking for honest bargain.
|
|
|
Reduced price 125$ for all -=Free Shipping to US/CA=-
|
|
|
Yeap, that's the picture ... don't know why it didn't display on my post ...
|
|
|
I added a picture but for some reasons it didn't work. Shipping is not included. If you take more kits, cheaper it will be. I will post more pictures after my work day.
|
|
|
|