Great news.
My X5 is running nice and stable so far.  

I'd definitely be interested in a group buy!!!

Hello, I'm searching for a cheap and working Antminer BB board. Shipping to Canada.

Thanks!

There will not be a 1-chip stick. The buck on the Compac has as low a baseline voltage as I can find (most bucks operate 0.6 to 0.8 volts minimum, that one will do 0.5) but the Bitfury's full range is from about 0.45 to 0.55 volts per ASIC. The "expected" power draw from the chip is also below 7 watts. It makes more sense to put two chips in series like the 2Pac, which shifts the buck's range away from impossible/suboptimal to 0.9-1.1 volts (this change increases overall system efficiency in three different ways) and puts the peak operating power at about 15W, which a lot of Compac and 2Pac owners like to approach.

The expected hash/power of a 2-chip BF16 Compac is from approximately 30GH at 2.5W up to approximately 130GH at 15W. These are approximate numbers based on expected performance of the chip gathered from others' test data. Once I have a working prototype the first thing I'll do - well, the first thing I'll do is post pictures and show it off but the second thing I'll do is work up a performance chart.

they would be good for a solo pool club.

If you get them done I would set the club up.

1 stick minimum to join the club.

I will go back and check rules of the last club,  Been a while.

if we had 50 people using 1 stick = 5000gh   that is  about 1 in 16 chance at a block in the next month.

if we had 50 people using 2 sticks = 10000 gh that is  about a 1 in 8 chance in a block in the next month.

Just received all the stick! I will repack them and ship them saturday. 

And if you really are into it for shits and giggles take your fried hash board and connect it to a car battery directly for a few seconds. can almost guarentee it will fry whats left of the bad section of the hash board and come back to life and no longer trigger the yellow cut out led on that psu .