antminer S5 Problem Asic

[dish67]

Hi

I have antminer S5 for about 2 month and my power is about 593.42 GH/S
Asic Status

my chains 1 is   -------- -------- -------- ------
my chains 2 is  oooooooo oooooooo oooooooo oooooo

do you know what happen with my antminer s5




https://i.imgur.com/YBWqfbj.jpg

[1715111484]

1715111484

[1715111484]

1715111484

[Amph]

again it seems a faulty asic, by the way what software for mining are you using?

we need to know more info to help you

[Zich]

Hi

I have antminer S5 for about 2 month and my power is about 593.42 GH/S
Asic Status

my chains 1 is   -------- -------- -------- ------
my chains 2 is  oooooooo oooooooo oooooooo oooooo

do you know what happen with my antminer s5

Maybe bad contact. Check all of ribbon cable, unplug the ribbon cable then plug in again.

[notlist3d]

Start out here - https://bitmain.zendesk.com/hc/en-us/articles/204875015-How-to-diagnose-S5-hashing-PCB

Assuming that does not help then go here  -  https://bitmain.zendesk.com/hc/en-us/articles/203559969-My-S5-hashes-at-about-600GH-S

And if that does not do anything then contact bitmain support.

[dish67]

Thank you for your answer

I try to change PSU and I have same result

I try to remove cable and re install cable same result

I check your URL  and  my board  is good

I just opened case with Bitmaintech ...  I wait about us

if your have another suggestion  just write me again tk..

[klaudiuxyx]

Hello dish67

I have the same problem, after one mounth of use , but with  chain 2.
You found the problem , Bitmaintech send you some answers ?

regards,
claudiu

[notlist3d]

Hello dish67

I have the same problem, after one mounth of use , but with  chain 2.
You found the problem , Bitmaintech send you some answers ?

regards,
claudiu

I think he been taken care of on account it says: Last Active:    May 19, 2015, 02:22:35 PM

But if I'm work please let us know!  Hopefully though OP is mining as we speak.

[GigaBit]

Try doing a factory reset.

[hpitcher]

I had that problem for a while I just made sure the firmware was up to date and after the firmware update it resolved the issue and now works great.