is staking working with masternode on the same wallet?
You can not stake on the wallet while running a masternode at the same time.
but you can open more than one wallet with the same computer. so you can stake with one wallet and use the others for masternodes for example.
For example read the following if you want to setup more then one master node using the same computer with one ip address.
You can change the port and the rpcport and setup more if you want.
You will need one copy of the data dir and the genius-qt.exe for each master node that you wan to run.
Here is an example of running three master nodes.
Folder that hold the block chain and .conf files
C:\SubFolders\geniusMasterNode1
C:\SubFolders\geniusMasterNode2
C:\SubFolders\geniusMasterNode3
Folders that contain the genius-qt.exe and the .bat files to launch the masternode
c:\MyFiles\geniusMN1\
c:\MyFiles\geniusMN2\
c:\MyFiles\geniusMN3\
Then in each of the above folders you would put in the following .bat files to launch the master nodes.
StartMasterNode1.bat
genius-qt -datadir=C:\SubFolders\geniusMasterNode1
StartMasterNode2.bat
genius-qt -datadir=C:\SubFolders\geniusMasterNode2
StartMasterNode3.bat
genius-qt -datadir=C:\SubFolders\geniusMasterNode3
Also in each of the data dir you need to put in a genius.conf file like the following.
Notice with each config they use a different port and a different rpcport for each genius.conf.
It is best to have staking=0 so it does not stake.
genius.conf for use with genius Master Node 1
Code:
maxconnections=100
rpcuser=YourRPCUser
rpcpassword=YourRPCPassword
rpcport=32222
port=9999
gen=0
server=1
daemon=1
staking=0
reservebalance=99999999
masternodeaddr=YouIPAddress:9999
masternode=1
masternodeprivkey=YourMasterKey
rpcallowip=127.0.0.1
genius.conf for use with genius Master Node 2
Code:
maxconnections=100
rpcuser=YourRPCUser
rpcpassword=YourRPCPassword
rpcport=32232
port=9998
gen=0
server=1
daemon=1
staking=0
reservebalance=99999999
masternodeaddr=YouIPAddress:9998
masternode=1
masternodeprivkey=YourMasterKey
rpcallowip=127.0.0.1
genius.conf for use with genius Master Node 3
Code:
maxconnections=100
rpcuser=YourRPCUser
rpcpassword=YourRPCPassword
rpcport=32242
port=9997
gen=0
server=1
daemon=1
staking=0
reservebalance=99999999
masternodeaddr=YouIPAddress:9997
masternode=1
masternodeprivkey=YourMasterKey
rpcallowip=127.0.0.1