Armory Not syncing up to current height

[ShoukaT]

Hello,

I have fully up to date BitcoinQt node here at my system. The blockchain is up to date.

But my armory doesn't go further from block no 334973.

I have tried everything.. removing / resintalling (multiple times) both Armory and Bitcoin Core but its been worthless. I get the same results

https://i.imgur.com/xEhy29H.jpg

the bitcoin QT works perfect, I even exported an address from Armory wallet and imported it Bitcoin core and it is showing its balance in Bitcoin. But it doesnt show anything in Armory and Armory doesnt go above the current height its stuck it..

Even tried letting armory run the bitcoind in the background... no luck...

Armory does its complete scan, takes around 30 mins but still doesnt go further from this height.

System is 64 bit Win 7
12GB RAM


Here is armory Log

http://pastebin.com/h9gveM3q

Really hope some developer can take a look at it and figure out the problem. Cuz I have tried everything that I can think of

[1715127010]

1715127010

[1715127010]

1715127010

[1715127010]

1715127010

[goatpig]

Your blockchain copy is missing blocks past the height Armory is stuck at. You have to redownload it.

[ShoukaT]

Bitcoin QT works fine.. does it work without complete blockchain?

[goatpig]

Core verifies blocks it downloads then commits them to the raw files. It doesn't verify the block was written properly, nor does it need to in order to function.

[tomo123]

I've got the same problem.  Do I need to re-download the entire blockchain or is it possible just to get the effected part?

[goatpig]

You can delete blk and rev files past the stuck point. It will only download the missing blocks but you'll have to reverify the chain in full.

[tomo123]

You can delete blk and rev files past the stuck point. It will only download the missing blocks but you'll have to reverify the chain in full.

Thanks will give it a shot