Could check if you could spread the load on the multi rail properly. If you tried to put the whole load on one rail it will shut down to self protect. Ironically lowering your clock when i mentioned you were probably trying to run full clock on a undervolted S1 would of probably given you the best hashrate
I believe that's what I did, could I modify a molex that's on another rail? I'm not sure how to tell.
As far as undervolting/underclocking I'm just trying to get it to run as if it were stock, I'll deal with all that later.
In my first post you could see I was getting a lot of HW errors running a full clock on it while it was undervolted. Was that probably why?
Like i said, you were trying to run too high clock on a modded S1, you needed to change the timing and clock based on the chip voltage. Not remove the mod. Voltage is what the pen modded resistors changed.
Thats why i said to lower the clock and change the timing. You could of possibly gotten near full speed but saved 100W or lost 25-30% hashrate but use 60% less power. Its just too late to check what clock it was meant to run at by the previous owner now.
Until you can put the mod back, all you can do is figure out how to spread the load on your PSU and underclock it so it doesnt overload it. Some molex to pci-e works, some doesnt. If you have a 2 molex to 1 PCI-e adapter, you might be able to run 1 blade on it slightly underclocked without melting the connectors.
