I would buy one for sure. I think coins that are not made from precious metals are useless and I rarely buy them unless Casascius made them.
Noted, I think silver is the way to go then if there aren't any objections.
"Initial Success or Total Failure" seems like detrimental wording for your cause
Maybe.. "No Surrender. Never Give Up."
I appreciate the suggestion, the phrase is near and dear to my heart and very relevant to an EOD coin but I will think about replacing it with something else. If anyone else has any opinions on this it would be appreciated.
With you all the way here EOD
Love the innovation. Just need to make sure that the desire for the wire doesn't stop the requirements of a cryptocoin ie that it is tamper proof. Also need to make sure that the private key has an element of protection from environmentals from the holo ie it's near enough airtight with the wire still in place
Only other thing I can think of is if it will fit in an airtite, and as such if ANACS would grade
But the wire is what sets this coin apart, so do all you can to keep it within the design
Hope you can tick all the boxes. This sounds like a unique offering. Hope to see it produced, and get one in my (gloved) hand. Any help I can offer, just shout up.
Thank you!
The wire is definitely a complex part of this project. I will have to make sure the depth is perfect so that the holo is flush and that I can get enough friction/adhesion that the holo will be torn when the pin is pulled.
In regard to getting it graded I am not sure. Does ANACS grade coins that are non round? I am not sure of the exact dimensions at this point but ANACS grading requirements might factor into that decision.
I hope I can too, I will definitely make sure it is done correctly or not do it at all. I am sure I will be asking for advice along the way