Gigabyte-GA-H110-D3A Mining board SUCKS! Can't get 6gpu up and running

[abhiseshakana]

I have a similar issue with this mobo too. It only recognizes 5 pci express x1 slots and does not recognize the pci express x16.

I have checked the gpu and it's cabels: 100% working. How can I make the pci express x16 work?

Thank you very very much

Try this bios setup

- Peripherals >> Initial Display Output >> IGFX
- Peripherals >> Above 4G Decoding >> Enabled
- M.I.T >> Max Link Speed >> Gen2
- Chipset >> Internal Graphics >> Enabled

Then you need to plug the display (monitor) cable to Onboard graphics port and don't forget to connect the PSU's Molex (4-Pin) power cable to both PCI-E power connectors on the motherboard.

[SamaritanMan]

I just connected to this mobo a PCI-E 1 to 4 splitter to the PCI-E 16X slot and anything works right.
I have done the mods into the bios, such as mining mode, Gen2, 4X bus enable etc..
Now i added another gpu, using the 1 to 4 splitter in HiveOs and i'm mining by days with no issues.
I think this mobo can handle up to 11 or 12 or more gpus, using these splitters also in the 1X riser slots, at least in HiveOs.

[fenomenyaa]

any tips for using pcie splitters 1x4 x ones? i will built 12 gpu setup with 2 pcix 1x4 ones.Which slots should i use ?