erre (OP)
Legendary
 Offline
Activity: 1666
Merit: 1205
|
 |
January 01, 2018, 09:09:46 AM |
|
Hi,
I imported an ether wallet with some tokens it it in etherdelta, but every time I try to deposit tokens to exchange I get this message:
"You tried to send an Ethereum transaction but there was an error. Make sure you have enough ETH in your "Wallet" column to pay for the gas fee. If you already have a pending transaction (enter your address on Etherscan to find out), please wait for it to confirm, or increase your "gas price" (in the upper right dropdown) and try again."
I have 0.014 ether on the address and setted 9 as gas price...what am I doing wrong?
|
|
|
|
erre (OP)
Legendary
Offline
Activity: 1666
Merit: 1205
|
|
January 01, 2018, 09:58:24 AM |
|
Nobody can give me a clue?
I used etherdelta in the past and no issues, the site may be slow sometimes but usually the tx was going trough without problems.
|
|
|
|
|
Idrisu
|
|
January 01, 2018, 04:58:50 PM |
|
The simple cure for your problem with etherdelta is to increase your ethereum balance. The balance is not enough to cover your transactions fees or gas. I experienced this last week and I have to increase my ethereum balance before transactions go through. However, your situation may be a different one but the account balance really do contribute to how much you can actually transfer at a time.
|
|
|
|
|
|
zikabra
|
|
January 01, 2018, 06:50:54 PM |
|
The simple cure for your problem with etherdelta is to increase your ethereum balance. The balance is not enough to cover your transactions fees or gas. I experienced this last week and I have to increase my ethereum balance before transactions go through. However, your situation may be a different one but the account balance really do contribute to how much you can actually transfer at a time.
He said he has 0.014eth in balance, it is more than enough to transfer tokens. OP I think you have to transfer ether to etherdelta smart contract too. |
|
|
|
|
roadwell890
Member
Offline
Activity: 490
Merit: 11
|
|
January 02, 2018, 04:50:40 AM |
|
now the Ethereum network is busy, all transactions require a bigger GAS, even for ED sizes only, I prefer to install gas 20 and above, for faster transactions ...
and make sure your balance is more than 0.01 ETH,
|
|
|
|
|
AlexaSonda
|
|
January 02, 2018, 05:49:53 AM |
|
Hi,
I imported an ether wallet with some tokens it it in etherdelta, but every time I try to deposit tokens to exchange I get this message:
"You tried to send an Ethereum transaction but there was an error. Make sure you have enough ETH in your "Wallet" column to pay for the gas fee. If you already have a pending transaction (enter your address on Etherscan to find out), please wait for it to confirm, or increase your "gas price" (in the upper right dropdown) and try again."
I have 0.014 ether on the address and setted 9 as gas price...what am I doing wrong?
0.014 ether is enough for gas, I think your connection is bad. maybe you can try it later or restart your connection. |
|
|
|
|
Flickkk
Full Member
Offline
Activity: 434
Merit: 101
Bounty Detective
|
|
January 02, 2018, 06:58:03 AM |
|
Maybe slow net.
or you access in some fake/phishing site bro.
always bookmark it man
|
|
|
|
erre (OP)
Legendary
Offline
Activity: 1666
Merit: 1205
|
|
January 04, 2018, 04:58:07 PM |
|
Thank you for your responses.
Here is my address: 0xEf272D104D0f678ECEB3F9B63B055C5158dAf9F0 -- 0.014 ETH
I correctly imported it in etherdelta, I have ether and the connection is stable (Wi-Fi and 4g I tried both), but I still have the same problem. As far as I can see I have no stuck txs.
Tried to send directly tokens but coinomi dapps is not working.
Any idea of what I can do now? Maybe I can use myetherwallet? (Never used it)
|
|
|
|
slumdog79
Newbie
Offline
Activity: 7
Merit: 0
|
|
January 05, 2018, 08:36:24 AM |
|
Thank you for your responses.
Here is my address: 0xEf272D104D0f678ECEB3F9B63B055C5158dAf9F0 -- 0.014 ETH
I correctly imported it in etherdelta, I have ether and the connection is stable (Wi-Fi and 4g I tried both), but I still have the same problem. As far as I can see I have no stuck txs.
Tried to send directly tokens but coinomi dapps is not working.
Any idea of what I can do now? Maybe I can use myetherwallet? (Never used it)
I have the same problem, I am using metamask and I have in my ethereum wallet 0.037ETH. I guess is etherdelta's problem. |
|
|
|
|
bmcorp
Newbie
Offline
Activity: 10
Merit: 0
|
|
January 06, 2018, 01:29:47 AM |
|
I have the same error since middle PM with metamask on ED... Always a popup error message : "You tried to send an Ethereum transaction but there was an error. Make sure you have enough ETH in your "Wallet" column to pay for the gas fee. If you already have a pending transaction (enter your address on Etherscan to find out), please wait for it to confirm, or increase your "gas price" (in the upper right dropdown) and try again." I hope it's not kitties again  I didn't try with my ledger nano S (not yet configured, just received it yesterday). Anyone tried ? |
|
|
|
|
|
simongoat
|
|
January 11, 2018, 04:58:14 PM |
|
I'm trying now with a ledger, leaving 0.02 for gas, putting gas up to 10 but its not working at all.
|
|
|
|
erre (OP)
Legendary
Offline
Activity: 1666
Merit: 1205
|
|
January 11, 2018, 08:17:18 PM |
|
I even increased my eth to 0.02 but nothing  Did someone managed to get some explanation or "official" answer? |
|
|
|
vlast01
Full Member
Offline
Activity: 364
Merit: 105
Dolphins Finance TRUSTED FINANCE
|
|
January 12, 2018, 01:28:39 AM |
|
Hi,
I imported an ether wallet with some tokens it it in etherdelta, but every time I try to deposit tokens to exchange I get this message:
"You tried to send an Ethereum transaction but there was an error. Make sure you have enough ETH in your "Wallet" column to pay for the gas fee. If you already have a pending transaction (enter your address on Etherscan to find out), please wait for it to confirm, or increase your "gas price" (in the upper right dropdown) and try again."
I have 0.014 ether on the address and setted 9 as gas price...what am I doing wrong?
The one thing that i notice that you did wrong is that you set your gas fee into 9 As you can see using mythetherwallet has a several rules in making any transactions. For some reason myetherwallet required you to have eth balance for you to cover the gas fee. It says that you should set your gas fee at an mininmum amount required which is 2100 gwei so just set your gas fee on 2100 gwei or higher for you to complete your hanged transactions. |
|
|
|
dadandandadan
Member
Offline
Activity: 86
Merit: 10
|
|
January 12, 2018, 03:30:09 PM |
|
Hi,
I imported an ether wallet with some tokens it it in etherdelta, but every time I try to deposit tokens to exchange I get this message:
"You tried to send an Ethereum transaction but there was an error. Make sure you have enough ETH in your "Wallet" column to pay for the gas fee. If you already have a pending transaction (enter your address on Etherscan to find out), please wait for it to confirm, or increase your "gas price" (in the upper right dropdown) and try again."
I have 0.014 ether on the address and setted 9 as gas price...what am I doing wrong?
I think your problem is that your gas fee is too low. It says in myetherwallet that you must set your gas fee on a minimum amount of 21000 gwei or else you can't complete any transaction. I think 21000 gwei is equal to 0.0005 Eth or approximately 5$ its is use to cover up your transaction or we can simple called it a transaction fee or transfer fee. |
|
|
|
|
Leamirra
|
|
January 14, 2018, 11:47:09 AM |
|
Hi,
I imported an ether wallet with some tokens it it in etherdelta, but every time I try to deposit tokens to exchange I get this message:
"You tried to send an Ethereum transaction but there was an error. Make sure you have enough ETH in your "Wallet" column to pay for the gas fee. If you already have a pending transaction (enter your address on Etherscan to find out), please wait for it to confirm, or increase your "gas price" (in the upper right dropdown) and try again."
I have 0.014 ether on the address and setted 9 as gas price...what am I doing wrong?
Hello! Have you been able to solve this problem? If at all of you it turned out, write the reason why there was such a situation. |
|
|
|
|
erre (OP)
Legendary
Offline
Activity: 1666
Merit: 1205
|
|
January 14, 2018, 04:40:40 PM |
|
Hi,
I imported an ether wallet with some tokens it it in etherdelta, but every time I try to deposit tokens to exchange I get this message:
"You tried to send an Ethereum transaction but there was an error. Make sure you have enough ETH in your "Wallet" column to pay for the gas fee. If you already have a pending transaction (enter your address on Etherscan to find out), please wait for it to confirm, or increase your "gas price" (in the upper right dropdown) and try again."
I have 0.014 ether on the address and setted 9 as gas price...what am I doing wrong?
Hello! Have you been able to solve this problem? If at all of you it turned out, write the reason why there was such a situation. Still didn't managed to solve it, I'm getting pretty frustrated, but I think it's etherdelta's problem. Still waiting for some explanation... |
|
|
|
LaLegiste
Full Member
Offline
Activity: 434
Merit: 100
https://eloncity.io/
|
|
January 15, 2018, 04:06:09 AM |
|
Hi,
I imported an ether wallet with some tokens it it in etherdelta, but every time I try to deposit tokens to exchange I get this message:
"You tried to send an Ethereum transaction but there was an error. Make sure you have enough ETH in your "Wallet" column to pay for the gas fee. If you already have a pending transaction (enter your address on Etherscan to find out), please wait for it to confirm, or increase your "gas price" (in the upper right dropdown) and try again."
I have 0.014 ether on the address and setted 9 as gas price...what am I doing wrong?
Hello! Have you been able to solve this problem? If at all of you it turned out, write the reason why there was such a situation. Still didn't managed to solve it, I'm getting pretty frustrated, but I think it's etherdelta's problem. Still waiting for some explanation... i guess the problem was too low gas price you set. better check https://ethgasstation.info/ for safelow gas price before every transaction you make. ethereum network is too congested recently. safelow gas price wasn't lower than 20 gwei last week but today it varies from 5 to 10 gwei. so you'd better try to deposit right now, i think it's the best opportunity to make it cheap and fast these days. also don't forget that 200 000 gas limit is needed for tokens. |
|
|
|
Fafabol
Member
Offline
Activity: 267
Merit: 11
|
|
January 15, 2018, 05:50:39 AM |
|
I have the same error since middle PM with metamask on ED... Always a popup error message : "You tried to send an Ethereum transaction but there was an error. Make sure you have enough ETH in your "Wallet" column to pay for the gas fee. If you already have a pending transaction (enter your address on Etherscan to find out), please wait for it to confirm, or increase your "gas price" (in the upper right dropdown) and try again." I hope it's not kitties again I didn't try with my ledger nano S (not yet configured, just received it yesterday). Anyone tried ? It means that it's already process but the transaction hash can't be found. That also happened to me and when I got pissed off I forgot it then I came back the other morning then to my surprise it got transacted. Etherdelta is too congested so I'm used to it yet I just used it rarely now. |
|
|
|
|
|
babykika2027
|
|
January 15, 2018, 03:16:51 PM |
|
I agree with the others, I think you have to increase your GAS cost, before you can check the price of GAS, because gas price can change at any time, the last few days GAS price is high enough, maybe you need to increase your MEW balance,
|
|
|
|
|
|
carlfebz2
|
|
January 15, 2018, 05:22:10 PM |
|
Hi,
I imported an ether wallet with some tokens it it in etherdelta, but every time I try to deposit tokens to exchange I get this message:
"You tried to send an Ethereum transaction but there was an error. Make sure you have enough ETH in your "Wallet" column to pay for the gas fee. If you already have a pending transaction (enter your address on Etherscan to find out), please wait for it to confirm, or increase your "gas price" (in the upper right dropdown) and try again."
I have 0.014 ether on the address and setted 9 as gas price...what am I doing wrong?
Setting out 9 gwei is really to low which Etherdelta would really give you that prompt regarding on that transaction. Better to set out higher gas. Usually I do set out 40-50 gwei depending if I'm in a rush I would set even more higher. For now I don't experience such problems regarding on selling or buying. Gas might be big but wont matter as long my trades are profitable then it would really be just fine. |
|
|
|
|
