Hi
I am hoping someone can help me
I have installed the driver for the USB Block Erupters but only 1 is reconised.
Every time I plug another one in to the same usb or a different usb I get that the Block Erupters is not reconsidered or that the USB device has failed.
2 of the 4 I have just come up with nothing and do not show in device manager.
I of those 2 does not have the LED light come on.
Can anyone help please
Ignore all the hub comments below, since nothing you stated indicates a hub is in use (or am i wrong?). If running from direct USB ports, insufficient current should not be an issue like it is with an under-powered hub
I had a similar issue where the driver on one port installed fine but not for the other. try the following:
1) reboot. if the driver is in but not initialised right, this time around it should recognise the BE instantly
2) check under devices and printers, and check the detailed properties for each device Identify the one(s) using generic controller drivers, uninstall the drivers, and try the zadig (or similar winusb driver) exe again. Some unplugging/replugging the BE(s) in question may help initialize the correct driver configuration/setup.
3) if needed reboot again
for me, this worked. Windows had setup 1 device as the correct winUSB driver, but the other as a generic UART 2012 bridge host or similar. The above 'method' got me up and running quickly.