I wil get this blade working.

[phazon307]

Ok so I had it up when I ran 192.168.1.254:8000 Then I accidently changed the Ip on the blade configuration page to 192.168.1.24 then I set my internet connection back to automatically get Ip address. I reset the blade tried doing the steps over again but nothing won't even bring up the blades configuration page but what happens when I enter my own ip address it still doesn't work when I change Ip4 Ip to 192.168.1.10 like before it still doesn't come up gives me a network error. I was able to bring it up before I just don't understand why it won't work anymore.

[1715085474]

1715085474

[1715085474]

1715085474

[1715085474]

1715085474

[1715085474]

1715085474

[1715085474]

1715085474

[sidehack]

You used the factory reset pads on the blade to set it back to default 192.168.1.254:8000?

You made sure your machine is subnet mask 255.255.255.0, gateway 192.168.1.1?

[phazon307]

yup!

[phazon307]

I even changed my router to have a 192.168.1.x Ip. takes me to bing everytime.

[soy]

I even changed my router to have a 192.168.1.x Ip. takes me to bing everytime.

Back when my Blade was working I sometimes had a failure to reset.  Maybe I didn't give it enough time to reset properly.  Tough finding a setup description on the V2 blades showing how to reset - probably because the V2.01 revs are pictured as not having a reset header.

I'd try shorting the factory reset pins with the Blade off.  Firing it up and watching the green LED flash then stop but leaving it powered for a full minute.  Then completely off for a full minute with the ethernet cable unplugged.  Then plug the ethernet cable back in, remove the jumper for the factory reset and put in a neutral position, e.g. single pin, then fire up and try accessing 192.168.1.254:8000 again.  Give it sufficient time to wake up fully.

[Skaterdiejosh]

I did his same shit to one of my blades actually two. All you have to do is use a paper clip and put it on pins 1-3 should say reset (1-3) on board in really small writing.. This will change it back to factory setting and you can try again. Once you get it back to factory change the ip to .201 and press update. I use .201 - .220 for all my blades Good luck hope this helps.......

[Roobotics]

When you factory reset make sure you watch the LED, I just tap the pins (as in repeatedly) until It cycles from blinking slow, then fast, then turns off. Once it's gone through that then it's really reset, otherwise I think it ignores it.