I've managed to place the LAN and the WAN on the same address, and I can't access my miner. Any advice/suggestions on how to reboot/restore the control card back to original default settings?
You will probably have to do a hard reset
Q:How to reset to the default state?
A: There is no reset button in the first batch of AntMiner. If AntMiner has to be reset, please follow these steps.
Step 1: Set your PC’s IP address as 192.168.2.x, and then connect AntMiner with your PC via a network cable.
Step2: Power on AntMiner for a while when it is inthe normal state. The WAN LED should be light.
Step3: With the miner still switched on use a piece of wire between the 2 points for more than 3 seconds. (see image below)
Note you do need to take you time as I found it difficult to access the points as the cables are in the way
The Antminer once reset will have a new ip address 192.168.2.99 instead of the default one on the label
Then access the miner via a browser 192.168.2.99 after a couple of minutes
Then start again with the setup
Good luck
I took this from the support thread...
fixing the image soon Saved img as jpeg in imgur...done