Your rigs need your help

[Keadyar]

Lol. Same problem here. Sub Saharan Africa. If you don't have problems with inconsistent supply of electricity, you will have dust problems. Such is the difficult mining tales we tell from this part of the world

you're right! Do not forget that the high temperature and dust are the main enemies of the miner. Therefore, unfortunately, many regions are not suitable for mining despite the inexpensive electricity.

[1715012763]

1715012763

[1715012763]

1715012763

[marcous]

Sounds trivial but this is something that is quite influential. All the things, we need to pay attention to. at least if it is clean it will get the ideal temperature. Thank you for being reminded, mate!

[Christinebeauty]

It is good to perform regular cleaning of your rig but you just have to take caution not to cause any mechanical damage to the machine. If you live close to a dusty load, frequent dusting is a necessity for maintaining your machine

[jony35490]

Yes, cleaning can be dangerous. I used vacuum cleaner instead of compressed air and almost damaged fan blades. It's important to be careful and patient.

Yeah it’s very very important to be careful while doing anything. Cause if we become impatient and start doing anything quickly then we may face so many problems. So we need to clean it very closely.       

[John46285]

If you were where I live, you would need to clean your rigs daily. My country is the fifth most polluted countries in the world according to WHO (World Health Organization), and dust existence is beyond measure. I clean my rig at least twice a week, and just 6 hours after I clean it, it collects dust. If I leave it for a week, my components become literally unrecognisable with dust covering every inch of them.
It gets frustrating, so don't blame me for getting lazy sometimes 

Yeah it’s must need to keep our rigs clean and fresh. Otherwise it may not work properly and we may get in touch with big problems.

[Beyerd17]

Yes, cleaning can be dangerous. I used vacuum cleaner instead of compressed air and almost damaged fan blades. It's important to be careful and patient.

Yeah it’s very very important to be careful while doing anything. Cause if we become impatient and start doing anything quickly then we may face so many problems. So we need to clean it very closely.        

If you are going to use a vacuum cleaner instead of compressed air, I would suggest you flip it to low power not to damage any components, best would be not to use a vacuum cleaner at all.

[mak013]

It is good to perform regular cleaning of your rig but you just have to take caution not to cause any mechanical damage to the machine. If you live close to a dusty load, frequent dusting is a necessity for maintaining your machine

Frequently, the next topic after cleaning is smth about "Help! My rigs shutted down and dont start".
If if works normally - dont touch. This is the main rule in IT.

[nc50lc]

Grabbing such an old thread 

Right, ever since these "Veil-signatured" guys (not all of them) came here, Mining (Altcoin) board become a total mess (There's something fishy going around).
It's as problematic as YoBit's recruited bounty hunters.

I got no problem with Signature Campaigns as I am wearing one too, but the spamming to boost the post count is a different scenario.
I have asked a mod to lock this thread.