Hi hi.
I have a little project on the go. I took an old PC tower. Gutted pretty much everything but the PSU out (no mother board . Dvdrom etc)
I have a put in 2 grid blades for mining.
And so a pair of 2pac geeko science usb miners
The grid blades need 12 volt power. So i just cut into one of the many 12v supply lines one is off a molex other from a feed to the old Motherboard.
Im told they use about 75watts each
Then a raspberry pi3 controls it. They work like a charm!
As for the usb miners. I have a pi 1 control them in the case too. They are both plugged into a usb powered hub. At 175mhz there pulling 6-8watts (i have a meter to track it)
However the voltage is terrible.
With NO load its 4.99v right at the usb miner stick , on but idle.
If i check other 5v feeds off the psu closer and before my grade 8 soildering skills i get 5.06v to 4.99v
That would all be ok but with one usb miner running. The voltage drops too 4.71v. With both 4.22v
Then the sticks sooner or later crash (or atleast 1 will)
I have tried 2 usb other hubs.
Other 5volt feeds off the PSU
Still the huge voltage drop.
I also found a random power plug i think for a very old portable house phone rated 5volt 3A. It test 5.08volt
I plugged that in the hub as the power And with both sticks running it drops to 4.89v at the stick.
This is a 480watt computer psu. Any idea why it cant handle powering a usb hub?
Russ
most likely a garbage generic psu
here is a link to a quality 5 volt psu that has voltage control
https://www.trcelectronics.com/ecomm/pdf/lrs75.pdfit will do 3 sticks and give 15 watts a stick
you could set to 5.5 volts which will sag to 5.1 or 5.2 as they all sag
sidehack has built a good usb hub can do six sticks at 10-15 watts
I personally use this one
https://bitcointalk.org/index.php?topic=5053711.msg48725753#msg48725753https://www.eyeboot.com/sipolar-10-port-usb-hub.html