Plagiarism. It was this post:
Desktop wallet setup for 1X2 masternode .
After the MN is up and running, you need to configure the desktop wallet accordingly. Here are the steps for Windows Wallet:
1. Open the 1X2 Coin Desktop Wallet.
2. Go to RECEIVE and create a New Address: MN1
3. Send 1000 1X2 to MN1.
4. Wait for 15 confirmations.
5. Go to Tools -> "Debug console - Console"
6. Type the following command: masternode outputs
7. Go to ** Tools -> "Open Masternode Configuration File"
8 Add the following entry:
Alias Address Privkey TxHash Output_index
* Alias: MN1
* Address: VPS_IP:PORT
* Privkey: Masternode Private Key
* TxHash: First value from Step 6
* Output index: Second value from Step 6
9. Save and close the file.
10. Go to Masternode Tab. If you tab is not shown, please enable it from: Settings - Options - Wallet - Show Masternodes Tab
11. Click Update status to see your node. If it is not shown, close the wallet and start it again. Make sure the wallet is unlocked.
12. Open Debug Console and type:
startmasternode "alias" "0" "MN1"
Original (or at least one version that came before your post):
Desktop wallet setup
After the MN is up and running, you need to configure the desktop wallet accordingly. Here are the steps for Windows Wallet
Open the LightPayCoin Coin Desktop Wallet.
Go to RECEIVE and create a New Address: MN1
Send 1000 LightPayCoin to MN1.
Wait for 15 confirmations.
Go to Tools -> "Debug console - Console"
Type the following command: masternode outputs
Go to ** Tools -> "Open Masternode Configuration File"
Add the following entry:
Alias Address Privkey TxHash Output_index
Alias: MN1
Address: VPS_IP:PORT
Privkey: Masternode Private Key
TxHash: First value from Step 6
Output index: Second value from Step 6
Save and close the file.
Go to Masternode Tab. If you tab is not shown, please enable it from: Settings - Options - Wallet - Show Masternodes Tab
Click Update status to see your node. If it is not shown, close the wallet and start it again. Make sure the wallet is unlocked.
Open Debug Console and type:
startmasternode "alias" "0" "MN1"
I understand you're just trying to give somebody helpful tips on how to set up a Masternode, but since you didn't properly credit the post you referenced, it is deemed plagiarism.
Edit: this post and the one below it, which is a more clear-cut example of plagiarism.