BzMiner v20.0.0What's in this release (v20.0.0)
x Decred: Added pool support
x New coin: nexellia
x New coin: dint (DinarTether)
x New coin: Larissa
--- Dynex Notes ---
Fine tuning dynex_pow_ratio will likely give you better results than default settings
intensity option will adjust how much vram is allowed to be used
Intel ARC support still only for POW
-- dynex_pow_ratio --
Bz allows you to dedicate individual cards to either POW or POUW on Dynex using this option.
This is an array of values, one for each gpu
In config.txt , an example for 3 gpus would be "dynex_pow_ratio": [1.0, 1.0, 1.0]
In command line, and example for 3 gpus would be --dynex_pow_ratio 1.0 1.0 1.0
In hive, extra config args (notice the quotes around the array), an example for 3 gpus would be "dynex_pow_ratio": "[1.0, 1.0, 1.0]"
A value of 0.0 will mine ONLY POUW
A value of 1.0 (Default) will mine both POUW and POW. It will choose a POW ratio that matches POUW
A value of 2.0 will fully mine only POW. Any value higher than 1.0 will not mine POUW
A value between 0.0 and 1.0 will determine how much POW is mined, values closer to 1.0 will mine POW more intensely, while values closer to 0.0 will mine POW less intensely
A value between 1.0 and 2.0 will determine how intensely to mine ONLY POW
A statistic in the status column of the tables called "pow slip" will show you how much POW hashrate above or below the POUW hashrate you are doing. If below (-), you should increase your pow hashrate. If above, you are wasting resources doing unecessary POW hashrate and you should lower your POW hashrate. NOTE: It is not possible to be rewarded for POW hashrate above your POUW hashrate!
-- Dynex intensity --
The "intensity" option in Bz will determine how much vram to utilize to mine Dynex. a value of 64 (highest), will use all available ram, a value of 1 will use the minimum amount of ram. Default is 0 (converts to 64 internally)
https://github.com/bzminer/bzminer/releases/tag/v20.0.0Check all links with first post from the developer!