Hi All
I have a few modular/semi modular PC psu's and was thinking of using the to pwer some S9 miners with 2 cards. Most of what i have are 1000w or higher.
They will be worthless selling so might be better put to use on some S9s powered with2 cards, so i would need x7 ouputs all together.
I think i could use an existing hard wired PCIE (6 pin or not) to power the control board.
Then on the dedicated high amp PCIE modular ouputs could i not solder on connections and 'share' the load so x2 on each output?
I have only seen x8 to x2 PCIE cables so could i not just splice in and solder another?
If this works i could do a few more miers in thsi set up as it would be low power and quite when set to 700/800w.
Anyone done this or got an opinion on it?
The PSU's will either go to waste tbh.
Pics attached.
https://imgur.com/a/Kdjxb0vThanks