Dogies guide saved me on a daisy chain setup. the dip switches must be done just as he does them.
Below is the proper dip switch settings pulled from dogie's guide
There is a 5 bit switch on each hashing board which must be configured to be unique in order for
the controller to detect it. Set the first miner's boards as "MINER1" in the below diagram, the
second's as "MINER2" etc. The long cable from one unit should be plugged into the empty
connection on the other to daisy chain the connections on the other.
You also have to wire the wires in order.
Seems the controller wants the boards in ascending order.
if the wires and boards are out of order
the controller skips the board.
so 1,2,3,4,5,6,7,8 all are found
1,2,3,4,5,6,8,7 it would skip number 7 since it is descending
So below the eight boards are numbered 1-8 and wired in order 1-8 and the gear works great! Thanks Dogie!