Power Flickers

[smracer]

This year so far I have had 2 less than 1 second power flickers that shut off all my miners.

I do not want to install battery backups on each machine but I will if I have to.

I can also just install 1 battery backup on my main machine with Teamviewer on it and remote into all the other machines and restart cgminer, etc.

Here is what I really want.

Some sort of capacitor based battery backup that can handle 25 amps at 240V for 2 seconds. So 6KW for 2 seconds.

I just want to eliminate the power flicker problem.

Does something like this exist? 

[1714703616]

1714703616

[1714703616]

1714703616

[rjk]

Set the BIOS to always start on power fail, and then make sure your init scripts are up to snuff.

[smracer]

That is the easiest way to do it I guess.

They automatically restart.  I have to reset the IP addesses though everytime because they forget them.

I write them to /etc/network/interfaces but I am booting from USB drives and it loses that info when it restarts.

So I can just make a script that writes /etc/network/interfaces

then does

/etc/init.d/networking restart
export DISPLAY=:0
./cgminer -c cgminer.conf

I just thought it would be easier if I could stick a capacitor inline with my power to my miners and have it take up the slack up the power browns out for 1 sec.

[rjk]

Capacitors as purely storage devices only work well with DC. You can't store AC current in a battery or a capacitor, you can only hope to correct some kinds of brownout conditions.

[smracer]

What if I take a single phase 240V AC motor and attach it to a balanced 100 lb iron disc?

Once it is up to speed it shouldn't be pulling much power to stay running since there is no load.

If there is a 1 second brownout the power from the motor will flow into my subpanel and keep the power on.

Just like a kinetic battery backup but homemade.

Would this work?

Am I correct in assuming the load would be small on the already spinning disc?

[rjk]

What if I take a single phase 240V AC motor and attach it to a balanced 100 lb iron disc?

Once it is up to speed it shouldn't be pulling much power to stay running since there is no load.

If there is a 1 second brownout the power from the motor will flow into my subpanel and keep the power on.

Just like a kinetic battery backup but homemade.

Would this work?

Am I correct in assuming the load would be small on the already spinning disc?

I don't know how great that would work for single or split phase. That technique is already in use for 3-phase systems, it was what was done before efficient UPSs based on batteries came along. Some datacenters could run for up to 15 seconds with a continuous 2MW load on such a device when it was sized correctly.