281
|
Bitcoin / Mining support / Re: "MP TEST FIRMWARE!" on S17 / T17 series control board?
|
on: December 29, 2019, 02:36:22 PM
|
I have test on my S9K ... is not true test but make idea And i confirm, on boot (bitmainer_setup.sh) SSH IS ACTIVED ! ########################### # dropbear NO_START=0
if [ ! -f /config/dropbear ] ; then echo NO_START=0 > /config/dropbear fi
cp /config/dropbear /etc/default/dropbear
###########################
|
|
|
283
|
Bitcoin / Mining support / Re: C5 control board Questions
|
on: December 27, 2019, 10:52:37 AM
|
Hi, i'm pretty sur, the control board xilink is universal ! no problem for replace C5 ... on m'y experiance, i plug T9+ control board on my S9 without any problem !!! just need connector 18pin and firmware for S9 on T9+ control board !
|
|
|
285
|
Bitcoin / Mining speculation / Re: Estimate power consumption at v/freq combination
|
on: December 07, 2019, 06:05:31 PM
|
interesting ... i have tested 950mv haha !!! run good ... but not serious run with this high voltage and not utility lol
So, is not good, S9 need OPENCORE higher than run voltage for good hash...
for exemple, i have tested opencord 910mv (for not over 1600W psu at startup) and run with 775mhz at 910mv , but not "full" hashing... but if i opencore at 940mv and run with same spec (910mv, 775mhz), no problem ! all hashboard is ok at full speed
|
|
|
287
|
Bitcoin / Mining support / Re: connect to miners over outside network ...
|
on: November 30, 2019, 03:04:42 PM
|
Hi , You need a fix ip network out. And you just only redirect the port : 80 = webinterface 22 = ssh In final you acces on your antminer is your external ip + port redirect , exemple : 50.150.200.210:XXXX (XXXX = your choice port) Its easy
|
|
|
288
|
Bitcoin / Mining software (miners) / Re: Antminer S9 and T9+ Firmware ASICBOOST original hacked , no dev fee hidden
|
on: November 24, 2019, 01:01:46 PM
|
Where's the source code?
Hi, the proof is there, you criticized me without even reading me! it's too bad ... In my first post I say that I do not have the source code for the simple reason that I use a BMMINER of origin! no change !!! therefore, you must ask for the sources at bitmain;) The function of my "firmware" or rather "mod" is that I apel the function ask by another way ... at least in a few words ... And as Taserz said I'm not a scammer, I help as I stink here!
|
|
|
289
|
Bitcoin / Mining software (miners) / Re: Antminer S9 and T9+ Firmware ASICBOOST original hacked , no dev fee hidden
|
on: November 21, 2019, 05:14:59 PM
|
No idea why a Mod would merit a post by someone who is breaking the cgminer license ... sigh ...
Good , 1: I offered to discover my firmware (you refused) 2: I said I was using an original Bmminer (you could have confirmed it) 3: you are as hard as the stone !!! 4: it's not like that you're going to advance science ... Really not good ... Come with me in PM and I prove to you that I'm not a scammer! So before criticizing everything, thank you for questioning you ... you did a lot for the comunity to see what I see on the forum, but it does not give you the right to spit on everyone like his, have apel his RESPECT! Thank you!
|
|
|
294
|
Economy / Computer hardware / (WTS) (EU) parts of miner D3 / T9 / T9+ / S7
|
on: October 02, 2019, 09:37:02 PM
|
Hi all, i sell part of miner see list : 1 x S7 complet run good 1 x S7 complet for parts 1 x D3 complet run good 1 x D3 partial run with 2 hashboard 3 x T9+ hash board for parts + case (same S9) 1 x T9+ complet, run partialy (arround 6th) 1 x Control board D3/L3+ run good If you need only one part, is possible ! just tell me. So if you need picture, is not problem, juste tell me you need I accepte escrow, but is utile ? the price is low lol If interessed, just propose me a price
|
|
|
295
|
Bitcoin / Hardware / Re: Antminer S9E 16th review
|
on: September 28, 2019, 08:35:11 PM
|
Hum ... i working for this ... i reshearch partership for hack this At this time, i'm agree to take control fan with succes (easyest) and agree to enter to "eco mode" ... but not run good, run at only 100mhz (arround 3,5th for 300w) ... I continue the reshearch , and i found, S9K / S9SE are chip probalby samsung "BM1393" , for comparaison S15 are "BM1391" and S17 ar "BM1397" PS : here, "chipless" are make a SDcard image for S9K , original firmware with unlock SSH and signature, run perfect good job for him
UP : New discover ... i modified the boot ! see my kernel log : bring up chain 0 2019-09-30 21:38:19 zynq.c:212:set_reset_hashboard: set_reset_hashboard = 0x0000fff9 2019-09-30 21:38:50 zynq.c:212:set_reset_hashboard: set_reset_hashboard = 0x0000fff8 2019-09-30 21:38:52 driver-btm-soc.c:3810:check_asic_num: without pre_open_core chain 0, find asic num = 60 2019-09-30 21:38:55 driver-btm-soc.c:4633:set_freq_by_chain: chain[0] set freq:425.00 2019-09-30 21:38:55 driver-btm-soc.c:4464:User Mode: chain[0] base freq 425.000000 over the max freq 385.000000 2019-09-30 21:38:56 driver-btm-soc.c:6133:bring_up_chain:
I set 425Mhz (overclock) but miner detect error and not hash but if i make clock under 385mhz, miner run good with underclock ! but i don't understand why only chain 0 is down ... i continu my reshearch
|
|
|
298
|
Bitcoin / Mining software (miners) / Re: Antminer T9+ Mod Eco FREE POWER : FULL FREE
|
on: September 22, 2019, 09:32:48 AM
|
Hi , my "mod" is now expired, no contain AsicBoost, no interest at this time... Now bitmain release T9+ 2019 firmware with multi option and eco mode, is very good for T9+ (only close SSH port is bad) , i thinks not better existing mod for eco ... 10.5TH at arround 950w ... is very good for T9+ ... Thanks for interesting by my mod
|
|
|
299
|
Bitcoin / Hardware / Re: Antminer S9E 16th review
|
on: September 20, 2019, 08:58:18 PM
|
Yes of corse ... the S9K / S9SE are newest disgn !!! new board, new chip ... all is new !!!
At this moment, i working for hack this, i take ssh with succes, now i try to hack this... S9 standard is easy ! but S9K is very hard to tweek, is totaly new system, run with CGminer (not BMminer) ...
|
|
|
|