How would i go about doing the i am trying to send the v1 to the v2 wallet when
i hit send nothing happens.
If you are trying to send 21+ million coins is the amount box flashing red? If so you hit a limit in the v1 wallet, there is a new build here that should remove that limit: https[Suspicious link removed]
That's what i am getting the box flashes red but i am only trying to transfer 21603 WAS
I sent all my coins in 20mil blocks. Or you can update the client that MrData provided that removes the issue. Depending on how many coins you have, going in block of 20mil would work.
Have you followed the instruction on the main website?
http://www.was.club/coinswap.htmlThese instructions are for after WeAreSatoshi v1 hits block 517,200; do not attempt before then.
Coin Swap Instructions
Important Notes:
Note 1: Do not attempt to swap WAS v1 to v2 by withdrawing from an exchange or online wallet, you must be using the 0.8.99.9 software wallet!
Note 2: If the amount of WAS v1 or the amount of WAS v2 that would be issued is less than the coin TX fee * 2 (0.0002 in both cases) then it will be ignored by the swap software.
Note 3: If you forget to enter a WAS v2 address or enter an invalid address (such as accidentally entering a WAS v1 address) your coins will be returned to you automatically.
Swap Directions:
Step 1: Open your WAS v1 client and select the Send tab.
Step 2: Put your new WAS v2 address in the 'Transaction comment' box. [You can find this in your WAS v2 client.]
Step 3: Put WQ3QSkqNiXGzu6xLSaeujccRRcUaPtEwxx in the 'Pay To' box.
Step 4: Put the amount you want to swap in the 'Amount' box.
Step 5: Click the Send button.
Step 6: Wait for the coins to get 10 confirms, you should receive your new WAS v2 within a few minutes at a 1000:1 ratio.