i repeat, test in progress. will not answer any email until bulk orders finish (3/11-13).

Should be fine as long as it can deliver the required amps on 12V rail.  Can't seem to find a spec sheet which shows 12V amp/watt rating.  It is a single rail design which is good as long just a question of enough 12V amps.

Closest thing I have seen in this photo of rating plate:
http://www.abs.com/Products/ProductDetail.aspx?ViewPage=2&ID=21

I can't make out the 12V wattage though.

Indeed. I am tired of all this BFL and ZTEX and other FPGA junk in the GPU forum.

I won't be buying any FPGA any time soon so might as well move it out of the way for now.

Thanks !

According to "People Familiar with the Matter" (TM)

Yeah. I know how PSU works ( if you have 1200 W PSU it does not pull all the 1200 but only how much you need ) but the sign that a bigger PSU is needed means that the power consumption was AGAIN underestimated and will probably end up being close to 3000 W.

I'm thinking I'll just cut the brick's power connector off and attach it to the 12v PCIe. It can always be reattached if need be.

Not sure how many can run off one PCIe connector though.