Antminer L3+ showing just 3 hashboards instead of 4

[theghost1980]

Hi there. Since yesterday I can see my panel as the following:


You can notice only 3 hashing boards working just fine. The #1 is missing. There is no xxxxxx or -------- or something else warning or saying something else.

I have tried reseting the miner to factory settings. Switching off/on several times. Changing the PSU unit. Testing the cables on the PSU (all are good 12.3 V+ each). So far I have no more ideas about what to do or try. Since yesterday I'm still waiting for technical support but they may be celebrating another Chinese year :S

Any help it would be very appreciated. Thanks for your time.

[1715131514]

1715131514

[1715131514]

1715131514

[xxcsu]

Did you tried to switch the cables from control board to hashing blades ?

https://shop.bitmain.com/workOrderGuide.htm

Create a repair ticket  , your L3+ should be under warranty

[theghost1980]

Did you tried to switch the cables from control board to hashing blades ?

https://shop.bitmain.com/workOrderGuide.htm

Create a repair ticket  , your L3+ should be under warranty

Thanks for answer. In deed it is damaged. I have tried changing the data cables of each hash board and the #1 is totally missing. So I'll send it for repair. It is pretty new but I asume that it was my responsibility. Basically I left another person "taking care of the miners" also the ventilation duct it had a curve (about 45 degrees) and I've learnt a big lesson it should be straight :S

Thanks man!

[dinger669]

How long did it take to get your board repaired?  I got a late sept batch and after a few hours the board disappeared.

[Jon_Bones]

this is a normal voltage? antminer L3+ dashboard half chips disappeared
https://www.youtube.com/watch?v=yKgijl3ZrfQ

[stevebills]

I have the same problem only 3 boards working and im sure its a faulty controller and did you get yours fixed?