oricon
Newbie
Offline
Activity: 11
Merit: 0
|
|
July 23, 2018, 06:02:26 PM |
|
How to install and compile? use SSH and log in as root user to your miner, default password is baikal. cd ~ sudo apt-get install git git clone https://github.com/cod3gen/sgminer-baikal.gitcd sgminer-baikal nano driver-baikal.h DO CHANGES AS ABOVE. If you have Giant N, no need to do changes. autoreconf -fi && ./configure && make cp /opt/scripta/bin/sgminer /opt/scripta/bin/sgminer_ORG This process will take about 15min. When its done you need to: screen -x sgminer ctrl+c to stop screen sessioncp sgminer /opt/scripta/bin/sgminer Confirm overwrite. If you cannot overwrite, you need to stop screen session again and retry copy. After a while you can reconnect to screen session(screen -x sgminer). When you do not need to see screen session any more, use ctrl+a+d keys to dettach! do you done step above with bold blue color? i try but unsuccess
|
|
|
|
|
|
|
The Bitcoin software, network, and concept is called "Bitcoin" with a capitalized "B". Bitcoin currency units are called "bitcoins" with a lowercase "b" -- this is often abbreviated BTC.
|
|
|
Advertised sites are not endorsed by the Bitcoin Forum. They may be unsafe, untrustworthy, or illegal in your jurisdiction.
|
Dudukian
Newbie
Offline
Activity: 143
Merit: 0
|
|
July 24, 2018, 06:33:53 PM |
|
Does anyone have any experience with Baikal repair service ? Four of my Baikal's went down from an electrical storm . Three are Giant B and 1 Giant X . Is it worth the effort to repair them ? I know the shipping will be steep .
Thanks , James
|
|
|
|
tboy32c
Jr. Member
Offline
Activity: 42
Merit: 25
|
|
July 25, 2018, 10:32:39 AM |
|
Does anyone have any experience with Baikal repair service ? Four of my Baikal's went down from an electrical storm . Three are Giant B and 1 Giant X . Is it worth the effort to repair them ? I know the shipping will be steep .
Thanks , James
If you have any others you could try swapping a known good Orange Pi/controller board with one of the ones that don't work. If only the Orange Pi or controller board died you're in luck since those are easy to replace (Baikal sells them separately if you contact them). If the hash boards died you may not be able to repair them depending on if the ASICs themselves fried of if it was any of the other components.
|
|
|
|
chinalovebtc
Newbie
Offline
Activity: 2
Merit: 0
|
|
July 26, 2018, 03:57:18 PM Last edit: July 26, 2018, 04:09:20 PM by chinalovebtc |
|
We are committed to the Baikal machine cracking, we have been studying the firmware for a long time, and have made some progress. If a friend wants to join our research team, we are very welcome to contact us.
Discord: greatwallbtc#5210
|
|
|
|
ZenoDiac
Jr. Member
Offline
Activity: 42
Merit: 1
|
|
July 26, 2018, 05:27:08 PM |
|
Does anyone have any experience with Baikal repair service ? Four of my Baikal's went down from an electrical storm . Three are Giant B and 1 Giant X . Is it worth the effort to repair them ? I know the shipping will be steep .
Thanks , James
Yea it depends on what's wrong hey. If they go on, but don't hash and you can't access the Dashboard, but can ping it = you need to take the SD card out and give it a set IP. If they go on, but don't hash and you can't access the Dashboard and can NOT ping it = you need to reflash the SD card or replace it with a new one. If they go on and all 3 lights light up during startup you might be in luck - boards are fine and the problem lies elsewhere. If they go on, but no blue lights light up during startup - there's something wrong with the board. I'm currently sitting with one hash board which I cannot get to work for the life of me. I've fixed a few but this one... Disassembled, cleaned, went through it with a magnifying glass, applied new heatpaste. I just can't get the blue light to go on during startup. It goes solid when the other 2 boards hash (tho itself doesn't hash). If they don't go on at all... Something is most likely fried - should be able to see it when disassembling. Eh, but it's a pain in the arse to send back with fees - and with the current profitability, I donno if it's worth the money sending back :/
|
|
|
|
piccolobit
Newbie
Offline
Activity: 43
Merit: 0
|
|
July 26, 2018, 08:45:01 PM |
|
Hello everyone, I would like to try to change my Baikal n, but I did not understand how it is done. is there a tutorial? the procedure can be done with windows or serves linux? THX
|
|
|
|
Dudukian
Newbie
Offline
Activity: 143
Merit: 0
|
|
July 27, 2018, 08:21:05 AM |
|
Does anyone have any experience with Baikal repair service ? Four of my Baikal's went down from an electrical storm . Three are Giant B and 1 Giant X . Is it worth the effort to repair them ? I know the shipping will be steep .
Thanks , James
Yea it depends on what's wrong hey. If they go on, but don't hash and you can't access the Dashboard, but can ping it = you need to take the SD card out and give it a set IP. If they go on, but don't hash and you can't access the Dashboard and can NOT ping it = you need to reflash the SD card or replace it with a new one. If they go on and all 3 lights light up during startup you might be in luck - boards are fine and the problem lies elsewhere. If they go on, but no blue lights light up during startup - there's something wrong with the board. I'm currently sitting with one hash board which I cannot get to work for the life of me. I've fixed a few but this one... Disassembled, cleaned, went through it with a magnifying glass, applied new heatpaste. I just can't get the blue light to go on during startup. It goes solid when the other 2 boards hash (tho itself doesn't hash). If they don't go on at all... Something is most likely fried - should be able to see it when disassembling. Eh, but it's a pain in the arse to send back with fees - and with the current profitability, I donno if it's worth the money sending back :/ All the lights come on during startup. They just don't show up on the gateway .
|
|
|
|
stokmak
Newbie
Offline
Activity: 7
Merit: 0
|
|
July 29, 2018, 08:07:21 PM |
|
|
|
|
|
sean123
Newbie
Offline
Activity: 59
Merit: 0
|
|
July 30, 2018, 06:31:36 PM |
|
|
|
|
|
agapes
Newbie
Offline
Activity: 41
Merit: 0
|
|
July 31, 2018, 06:37:34 AM |
|
there is one way we can trust for the guy that firmware is legit give access to his computer on TeamViewer and showing the screen live that working
|
|
|
|
agapes
Newbie
Offline
Activity: 41
Merit: 0
|
|
July 31, 2018, 06:40:55 AM |
|
iv saw something weird on all videos, the browser connected to VPN??? is that normal or what?
|
|
|
|
Bob-Bit
Jr. Member
Offline
Activity: 241
Merit: 6
|
|
July 31, 2018, 04:09:36 PM |
|
Anyone know where I could source a fan for a Baikal A900? Can't find the same one anywhere. I don't mind if I have to splice wires with the end of the plug for the old fan. I'm a simple man.
|
★ PRiVCY ➢ Own Your Privacy! ➢ Best privacy crypto-market! ★ ✈✈✈[PoW/PoS]✅[Tor]✅✈✈✈ (https://privcy.eu/)
|
|
|
sean123
Newbie
Offline
Activity: 59
Merit: 0
|
|
August 01, 2018, 06:07:04 PM |
|
Hi all is there any new on the n range update many thanks in advance
|
|
|
|
kavjlaeg
Newbie
Offline
Activity: 66
Merit: 0
|
|
August 01, 2018, 07:15:04 PM |
|
Rebuild of Baikal`s SG Miner for Giant X10 / N / B
hello code3gen, make your sgminer mod on 7pc baikal B sorry, hashrate MMR and working pools, some as stock. in web LBRY up from 42 to 46 Gh/s pools NO hash up ( https://www.miningrigrentals.com/rigs/88361 I mod by code3gen baikal`s B at 30 Jul thks.
|
|
|
|
TheRealCashen
Newbie
Offline
Activity: 56
Merit: 0
|
|
August 01, 2018, 11:42:05 PM |
|
Followed the directions and i'm getting 0 accepted shares with pascal, but Lbry works just fine.
any ideas?
|
|
|
|
jaryfaaad
Newbie
Offline
Activity: 28
Merit: 0
|
|
August 03, 2018, 02:22:06 PM |
|
Have updated the link and that might be useful to some people.
|
|
|
|
cod3gen (OP)
Member
Offline
Activity: 311
Merit: 69
PowerMining.pw
|
|
August 04, 2018, 12:11:10 AM |
|
hello code3gen, make your sgminer mod on 7pc baikal B sorry, hashrate MMR and working pools, some as stock. in web LBRY up from 42 to 46 Gh/s pools NO hash up ( https://www.miningrigrentals.com/rigs/88361 I mod by code3gen baikal`s B at 30 Jul thks. Not sure what you mean, i see very fluctating hashrate on your miners on MRR..
|
|
|
|
cod3gen (OP)
Member
Offline
Activity: 311
Merit: 69
PowerMining.pw
|
|
August 04, 2018, 12:14:46 AM |
|
hello cod3gen I bought bk-n240 Browse https://github.com/cod3gen/sgminer-baikalFollow the steps written on the website to rebuild use root sudo apt-get install git git clone https://github.com/cod3gen/sgminer-baikal.gitcd sgminer-baikal autoreconf -fi && ./configure && make cp /opt/scripta/bin/sgminer /opt/scripta/bin/sgminer_ORG cp sgminer /opt/scripta/bin/sgminer When executing sgminer The message that appears is Started sgminer 5.6.2-BK_cod3gen_MOD * using Jansson 2.7 No devices detected! Waiting for USB hotplug devices or press q to quit Is my step missing Have never been tried on 240k version, and from your message it does not work on it "No devices detected"
|
|
|
|
piccolobit
Newbie
Offline
Activity: 43
Merit: 0
|
|
August 04, 2018, 10:11:35 AM |
|
hi, my giant N+ change clock from 200 to 420....but hashrate is the same....is normal? THX
|
|
|
|
sean123
Newbie
Offline
Activity: 59
Merit: 0
|
|
August 05, 2018, 06:36:11 AM |
|
|
|
|
|
|