Okay got my t3t 39th model today.
set it to Factory settings and it is doing around 39th on factory setting.
still audio tuning have to wait a bit.
one board is not fond of this setting as it drops tons and tons and tons of HW's
watts are 2378 for about 37 th or 64 watts a th so so frankly I may have rushed test so say 38 th and 2378 watts = 62 watts a th
Switched to balance rather than factory and power dropped to 2050 watts waiting for it to tune 2050 watts is a lot better then 2378.
edit 2070 watts 32.5 to 33.6 on balanced this is a bit better then an m10 on top speed. not 100% fan settings these do not surprise me not needed in balanced fans should be 80% since the watts are 300 lower this is simply a waste of power on the part of innosilicon note the temps are much lower then called for on the balanced setting
So efficiency + setting dropped me to 1757 watts and 30th
Fucking fans still 100%
I will let this settle in so 58 watts a th is meh.
Not as good as my t17
not as good as my m20s
not as good as my s17
At this point all my gear is in house other then the innosilicon t57
This was a t39 model and the specs and listing for the t39 have vanished on their website.
But as I recall it is not spec or even 10% of spec.
That is very typical of them less hash and more power per gh is very common when you buy from them.
But they tend to keep working and don’t break.
It is so far off spec I think I am not going to buy a 57t
I will wait on the order for the t50 to arrive in August.
And we will mine and hold for two months or more.