The wallet isn't synchronized. Give still nodes, please.
Edit--There is additional info below the image.
You need to be using the updated client - Download links are on the Opening Post Pg1
Make sure that the wallet is not running.
In Windows go to "%appdata%/CapitalCoin" in linux go to "~/.CapitalCoin"
delete the following.
database - Folder
.lock
blk0001.dat
blkindex.dat
db.log
debug.log
peers.dat
update your config file with the following node.
noirc=1
addnode=54.68.5.44
addnode=95.85.20.219
addnode=54.68.5.44
addnode=194.68.37.100
addnode=77.144.27.130
Download the Bootstarp file
BootStrapThe file is a zip file so you need to extract it into the Capitalcoin folder.
Now the only files you should have in your Capitalcoin folder should be
CapitalCoin.conf
wallet.dat
start your wallet client.
Please note that it will take some time for you to see the wallet screen as it's going to start importing blockchain from the bootstrap file.
once it's done "bootstrap.dat" would automatically be renamed to "bootstrap.dat.old"
In linux you can to the following to check the progress "tail -f ~/.CapitalCoin/debug.log"
once is done your wallet should open and it should continue to sync from the network.
Info: even with the bootstrap file It made take close to 5 hours for you to be back in sync, please verify that you are sync with the official block explore.
http://capitalcoin.sci-hub.ir/chain/CapitalCoinInfo: When the wallet client screen opens it will still be syncing, as show in the below image. Look at the green boxes.
In an extreme case where you still can not sync follow these steps.
Use this as your CapitalCoin.conf (change the RPC user and password.)
rpcuser=SomeUser
rpcpassword=SomePassword
rpcallowip=127.0.0.1
rpcport=22133
port=22033
daemon=1
server=0
listen=0
dnsseed=0
noirc=1
maxconnections=1
connect=54.68.5.44
That will make your client only connect to the block explorer and it should not try to connect to any other node.
Once your are back in sync then go back to using the CapitalCoin.conf on the OP