because we are using a proportional payout system. when our coins mature you will be getting a fixed payout per share (also normally called PPS which normally comes with high fees) but we will stick with a 1-2% fee and a block finders bonus

restarted the pool to enable vardiff plz retry

Nice job fixing it. Question since I am tormenting a poor little jally right now: Do you remember what the temps were, and do you have one heat sink or two in your unit? Did it have all 8 chips on there?

Thanks for the tip!

Out of curiosity which thermal paste did you go with?

Sure thing! Just added an eMark wallet to OP.

If you like it, my DEM addr is NXpiA5xTVKQSE9AxYGaU4eaKmF12fawacp - Thanks!

 35Gh is ok, it means your power side was running too hot.

What is the temperature reported from your miner?  If it is around 70c then its reasonable.

Hi all!! please help me

I can mining solo but i can't get coins to my wallet. When i add the command in bfgminer to get coins in my wallet: --coinbase-addr ZWUfbegHh325UeYy3pzMz6Y7NxNgAQwRh7
 
When and i open bfgminer automatically closes with a error: address is invalid
 
If i delete the command --coinbase-addr ZWUfbegHh325UeYy3pzMz6Y7NxNgAQwRh7 work perfecly finding blocks...
 
I don't know what to do. Help me please. I have the same problem when i will mining Emark or Zetacoin. This adress is of receive Zetacoin.

Example I have this in my .conf of zetacoin:
 
rpcuser=amigos895
rpcpassword=bitcointalk
maxconnection=200
rpcallowip=127.0.0.1
rpcallowip=192.168.1.33
rpcport=17335
server=1
daemon=1
listen=1
addnode=105.236.111.72
 
 
And this in my shorcut of bfgminer:
"C:\Users\invencible895\Desktop\minar solo zetacoin\bfgminer.exe" -o 127.0.0.1:17335 -u amigos895 -p bitcointalk

 

I don't gain nothing

If your heatsink to chip contact is good then try this.  If the heatsink contact is bad then the chips will stay slow.

Get a fan blowing onto the mosfets,  The core temp should rise to 70c and the hash rate will rise. 

 32Gh without mosfet cooling to 35Gh with mosfet cooling is the minimum I would be looking for.


If the mosfets on the power control get too hot, it will throttle the board.