DPS-2000bbb modding - Which pins to connect?

[polymer_city]

Hi can, I have connected A6 - C2 to power on - It powers on..

But it then goes to standby after a couple of minutes

What is the other pins need to be connected to make it stay on?

Thanks!!

[Tupsu]

What is the other pins need to be connected to make it stay on?



http://static.rcgroups.net/forums/attachments/3/1/3/5/4/3/a3982688-159-Bladecenter%202000w%20PS.jpg

You need a fan.

[polymer_city]

I have fans, I need to make it come out of standby mode

I'm testing and if I short C2 and C1 it comes out of standby.. But it doesn't seem to work all the time??

[Tupsu]

I have fans, I need to make it come out of standby mode

I'm testing and if I short C2 and C1 it comes out of standby.. But it doesn't seem to work all the time??

Works for me with C2 and A6   for 2 sngle PSU-s.

[polymer_city]

This is driving me insane..

I have 3 psu's

1 x 2000bb
2 x 2000bbb

All do the same thing... after 1min DC light does out?

[Tupsu]

This is driving me insane..

I have 3 psu's

1 x 2000bb
2 x 2000bbb

All do the same thing... after 1min DC light does out?

Put a load to 12V  and it will work.

[polymer_city]

Ok, not sure what was happening, it may have been a bad ground / dry solder...

Think one was too hot testing without fan and now with load its working.. done nothing different just changed jumper cable.

Thanks for the help