If you read the previous post about orphans it would explain a bit. Plus it's not new. I have seen this a few times.
I read your previous post. I'm not skipping over yours like you obviously are to mine. I asked several questions that went unanswered. It is still not syncing. With 13 connections and the .conf only having one node added. The one you linked me.
Neither you or the dev have been able to assist with this issue. The dev says you're on the wrong chain, you say your chain is the same as his bootstrap.
My last post was 12 minutes ago. Do you think it's normal to wait 12 minutes for a new chain to sync on a 120 mbps connection?
I guess your right. But the point I was trying to get across was until the difficulty is higher and the chains moves more slowly then the wallet will always show that syncing at 0 hours behind. If you watch the blockchain it does move accordingly and at a fast rate. I was not really concerned about the connection.
It should only show as behind until it syncs. Once it has downloaded all of the required data to sync there should be a checkmark and it should be up to date. At that point, I can mine. I cannot begin solo-mining before that because it is waiting for the chain to download.
I had it sync, once, but then after I restarted the wallet it wouldn't sync again. This was a couple chain deletions ago, maybe I was on the wrong chain. Now, it synced a few minutes ago, but I had a very basic conf and had to do some modifications if I want to begin solo-mining. However, I get 2 different errors based on whether I use xrev.conf or XrevCore.conf. Either way, the mining did not work the first time around. Now I'm still waiting for the chain to sync. Restarting the wallet has resulted in a waiting period of 10 minutes so far and it's only at 58% of "synchronizing additional data". It might sync, or it might get to like 90% and start over again at 0%.
What have you put in your .conf to mine? What have you named your .conf?
I get a "no method" error when using xrev.conf. In my experience, the .conf is supposed to have the same name as the folder it's in. Obviously, I have no idea if this is necessary, but when I add a .conf that is named XrevCore.conf it says "connection refused".
.conf
rpcuser=username
rpcpassword=password
rpcallowip=127.0.0.1
rpcport=9091
port=9090
server=1
listen=1
daemon=1
addnode=185.173.33.92
.bat
ccminer-x64 -a x11 -o
http://127.0.0.1:9091 -u username -p password --show-diff --cpu-priority 4
pause
What am I doing wrong? I've used the same setup to mine dozens of coins solo.
The wallet is finally up-to-date after about 20 minutes. All I did is restart it right after it was fully up-to-date, and it took 20 minutes to sync again. Still getting connection refused, though.
[2017-04-25 08:18:00] HTTP request failed: Failed to connect to 127.0.0.1 port 9091: Connection refused
[2017-04-25 08:18:00] get_work failed, retry after 30 seconds
I'd have to restart my wallet and wait another 20 minutes to try something else. lol.
