✅|ANN| 🌍DESIRE |NeoScrypt| |🔨MasterNodes🔨| - COIN OF YOUR DREAMS!

[SmallRig]

I think Yobit fees has been paid.. within this week desire will be there.

[Yankeeruinx]

Should be listed on Saturday I believe. Has CMC been applied for so people can research DSR?

[chikavladimir]

I have setup MN on a VPS and trying to configure my masternode.config at my local controller wallet.

In the below format, what does
COLLATERAL_TX_FOR_desireMN1
&
OUTPUT_NO_FOR_desireMN1
means?

Format:
desireMN1 IP:9919 MASTERNODE_PRIVKEY_FOR_desireMN1 COLLATERAL_TX_FOR_desireMN1 OUTPUT_NO_FOR_desireMN1

the command "masternode outputs" will give you what you need

I get this when i run masternode outputs

{
  "4MASKEDXXXXXXXXXXXXXXXXXXXXXXXMASKEDXXXXXXXXXXXXX7": "1"
}

so what should i substitute  these two with? COLLATERAL_TX_FOR_desireMN1 OUTPUT_NO_FOR_desireMN1

Format:
desireMN1 IP:9919 MASTERNODE_PRIVKEY_FOR_desireMN1 4MASKEDXXXXXXXXXXXXXXXXXXXXXXXMASKEDXXXXXXXXXXXXX7 1

Thank you! It is preenabled now!

Is it possible to create multiple nodes and enable them via single controller wallet?

For Desire MN, I don't think it's possible to have more than 1 MN per public IP.

Right, i tried for 3 nodes and one started and other two went missing, for the same public IP. I will try if any other method works. Thank you!

you cannot change the port number of the node because 9919 is hard coded in the wallet. so you can only run one masternode per external IP

Hello. I cannot configure Masternode on VPS server  using ipv6 address, my local wallet say"incorrect ip", but when i use ipv4 - it's all right. 
Also in local wallet in list of masternodes i see only ipv4 addresses
Desire wallet cannot use ipv6 ?

[bomba141]

The GPU MINING Is Good For Me

[Skyhorse]

I have problem in masternode set. I was follow all the rest of guide and tried did many times but still has error: "Not capable masternode: Masternode not in masternode list".

Please help me to fix its.

Thank you

[achlyss]

I have problem the first wallet run at vps can not be loaded

[trgnn]

Is yobit safe ? It's a real question, I heard a lot about them.

Are you using it guys ?

[Toxic_1988]

I think Yobit fees has been paid.. within this week desire will be there.

Nice, can't wait to see it on there.

Should be listed on Saturday I believe. Has CMC been applied for so people can research DSR?

CMC need 24h volume must be at least $10k

[coco23]

I have problem in masternode set. I was follow all the rest of guide and tried did many times but still has error: "Not capable masternode: Masternode not in masternode list".

Please help me to fix its.

Thank you

Did you wait for enough confirmations on your 0-address? (I don't know how many you need exactly, but I saw this error on my MN when I only had a few confirmations)

[Yankeeruinx]

Yes which DSR is currently over $10k and CMC added Coinsmarket as a recognised exchange yesterday so can apply now.

https://coinmarketcap.com/exchanges/coinsmarkets/

If it can be on CMC before Yobit then it will be great as when it lists first thing people will do is check CMC and if it's not there then a lot of people won't be interested.

[Adriano2010]

Is running ok masternodes or have any issues when setting it or when running? I want to run a masternode this month. How many coins you get in 24 hours?

[candyiman]

My masternode has not received payment since about 20 hours  

Yet In my Masternode page it apperas as Enabled

I figured that my Wallet was not in sync (confirmations was not going further)

I restarted my Wallet  no block source available

Reindex WAllet

OK Wallet is now syn



How do I know that my MAsternode is working or not It is appeared as Enabled and active since 2 days and some hours


Question How do I stop Masternode?   in order to REstart it again?

I tried mnsync status  its all ok but i "dont believe" it

[AltMiner.net]

🛠 NEW MINING POOL ADDED 🛠

https://altminer.net
Low latency, scalable and secure mining pool infrastructure
Automatic payouts every 120 minutes
No registration required

▶️▶️▶️ How to mine❓
Use the following parameters at your preferred mining software (replace WALLET with your wallet address):

Code:

-a neoscrypt -o stratum+tcp://eu1.altminer.net:4233 -u WALLET -p c=DESIRE

▶️▶️▶️ How to use a different difficulty❓
You can use the parameter d=? in your password to set the desired difficulty, good for NiceHash etc.

Code:

-a neoscrypt -o stratum+tcp://eu1.altminer.net:4233 -u WALLET -p c=DESIRE,d=8

▶️▶️▶️ Explorer
https://altminer.net/explorer/DESIRE

▶️▶️▶️ Nodelist
https://altminer.net/explorer/peers?id=1973

▶️▶️▶️ Benchmarks and tuning settings
https://altminer.net/bench?algo=neoscrypt

[lazy_boozer]

My masternode has not received payment since about 20 hours  

Yet In my Masternode page it apperas as Enabled

I figured that my Wallet was not in sync (confirmations was not going further)

I restarted my Wallet  no block source available

Reindex WAllet

OK Wallet is now syn



How do I know that my MAsternode is working or not It is appeared as Enabled and active since 2 days and some hours


Question How do I stop Masternode?   in order to REstart it again?

I tried mnsync status  its all ok but i "dont believe" it

Indeed, today about 40% of the master stuck at the block 9062. It happened due to the branching of the network, the network itself stabilized within 20 - 30 minutes.

Do not worry, the command "masternode status" gives truthful information.

[freshstorm92]

Is running ok masternodes or have any issues when setting it or when running? I want to run a masternode this month. How many coins you get in 24 hours?

MN work smoothly with me. after first 24 hours I receive about 14 coins. today the wallet pay me every 7 hours. very well, you only need 1000 coins to run a MN

[candyiman]

My masternode has not received payment since about 20 hours  

Yet In my Masternode page it apperas as Enabled

I figured that my Wallet was not in sync (confirmations was not going further)

I restarted my Wallet  no block source available

Reindex WAllet

OK Wallet is now syn



How do I know that my MAsternode is working or not It is appeared as Enabled and active since 2 days and some hours


Question How do I stop Masternode?   in order to REstart it again?

I tried mnsync status  its all ok but i "dont believe" it

Indeed, today about 40% of the master stuck at the block 9062. It happened due to the branching of the network, the network itself stabilized within 20 - 30 minutes.

Do not worry, the command "masternode status" gives truthful information.

Ok but Ive lost my last 2-3 payments right?

[freshstorm92]

yea right, if over 20 hours, you then lost about 3 times of payment

[lazy_boozer]

Vote for adding DESIRE to C-CEX !!

[SmallRig]

Price is now reaching 1$ per coin at a stable rise .. Not a pump or dump !!


Join Discord
https://discord.gg/wrk9uHB

[sc0rp1on]

Does anyone here know about the best clock setting rough estimate for 1050ti/1060 3gb/rx470/rx570/rx480?