Ok. I just have some hash like that:
RX 470 = 19-20 mh
1070 = 51-54 mh
1080 = 69 mh
I'm getting a lot lower mhs with gtx 1070. What are your settings for this? Try using Alexis miner. That seems to be pushing out the best hash rate for nvidias |
|
|
|
Most coins that do a 0 or 1 coin block reward for a certain amount of blocks are more vulnerable to getting DDOSed as soon as the chain switches over to the full block reward. To combat that, the block reward for Bulwark starts at .01BWK/block and slowly ramps up to the full 50BWK/block over the first 960 blocks. |
|
|
|
I might mine this. It seems very similar to Solaris which has been rising. I notice at least one team member was on the Signatum team though.
entire team is from signatum who? cro, skank and doc? None of those people are associated with the Bulwark project in any way, shape, or form. |
|
|
|
Most of your links are not working. Whats the problem?
Thanks for the heads up. I'm not used to BCT formatting. All links are fixed. |
|
|
|
|
Please note that your wallet is not stuck at 50% sync. It has synced up the blockchain just fine and is attempt to sync masternodes that do not yet exist. Everything on the wallet still works 100% and the issue will resolve itself once we get a little further along.
|
|
|
|
 Bulwark (BWK) is a community-oriented coin offering new entrants the opportunity to join a promising project at inception. We offer a simple value proposition with no grandiose promise: we will deliver a privacy hardware masternode coin that works today and into the future by leveraging best practices from both DASH and PIVX. No fanciful visions with a limited prospect of delivery, but a working coin on a working platform with support into the future. With no ICO and a small premine, early buyers will have ground-floor access to a privacy coin offering a blend of the best available privacy coin technology. Masternodes are a fundamental part of this coin's vision and will serve to secure the network, stabilize the market by incentivizing holding, and provide important functionality. Information: The Team CoinmarketcapBulwark Whitepaper Block Reward Schedule Roadmap Specifications: Ticker:BWK Algorithm: NIST5 RPC Port: 52541 P2P Port: 52543 Block Spacing: 90 Seconds Difficulty Algorithm: Dark Gravity Wave v3.0 Block Size: 1MB Mined/Minted Maturity: 67 Blocks (~100 Minutes) Confirmation: 6 Blocks (~9 Minutes) Circulation (1 Year): 14,505,720 BWK Circulation (5 Years): 27,668,220 BWK PoW Period nHeight ≤ 182,700 PoS Period nHeight ≥ 182,701 Protocol Support: IPV4, IPV6, TOR, I2P Social Platforms: RedditTwitterFacebookGithubWebsiteExplorerDownloadsExchanges: CryptoBridgeCryptopia |
|
|
|
|
I've no position on whether or not Koinbi is a legitimate exchange considering it's new and has yet to find its legs.
I do however know that you need to set up 2FA on your account in order to withdraw funds. It doesn't explicitly say it, the withdraw amount just disappears when you click withdraw. Go to settings, set up 2FA, then you can withdraw funds no problem. I tested this a couple times yesterday.
I haven't dealt with long processing times. Hopefully it's an issue that will get resolved and not the exchange exit scamming after 2 days (seems like an incredibly short time frame for an exit scam)
|
|
|
|
Haven't hear about POLYTIMOS algo. How is it secured against sha256, blake, equihash etc? What is the difference between those stated above? I would be happy to check any information linked to it's algo or any research about it. Thanks!
It looks like Polytimos is a blend of Skein, Shabal, Echo, Luffa, Fugue, and Gost. |
|
|
|
Guys,
what miner do you use for nvidia ?
I try tpruvot 2.2.2 with nova
(ccminer -a sib -o stratum+tcp://poly.suprnova.cc:7935 -u -p)
but,
1. only 7mh for 1060 6 - too low compare to 1080ti 39
2. all shares are rejected cs
accepted: 0/1 (diff 0.055), 37.47 MH/s booooo
[2017-11-16 23:34:59] reject reason: low difficulty share of 4.733145897229588e-10
How can i fix this problem ?
Thank you in advance
https://github.com/punxsutawneyphil/ccminer/releases\ Am i missing something, i downloaded the ccminer, but there are no bat files to edit? They usually don't. You have to make the bat files yourself in notepad or a similar text editor. If you need help with this send me a PM and I'll provide you with instructions on how to do this and help you get set up on a pool. |
|
|
|
Happy to see it land on an exchange so soon after launch. Should prevent mass miner dumps that usually occur when exchange listings end up being a month or two out from launch for PoW coins. |
|
|
|
|
Sent all my bitshares to polo and it's been stuck for about 2 weeks now. Sent a small test amount, worked fine. Sent the remainder of my bitshares, wallet goes into maintenance mode, all my BTS has been floating in the ether since then and been irretrievable. I would love for the BTS team to provide some semblance of an official announcement to ease my mind that I didn't just ether all my BTS or to let me know that I just lost it all and can stop paying attention to this project.
|
|
|
|
Dev, seriously, without jokes.
- Have a restart.
- Create a complete POS coin. (or with premined 1000 POW blocks)
- Change head of thread to [ANN][ICO][POS][MGN]MAGNA COIN MASTERNODES ZEROCOIN ATOMIC SWAPS
- For distribution (and net stability) you can make low supply airdrop (50 coin for paticipiant)
You will get many people wantes to buy you masternodes, seriously.
POW coin and fair start - not yours, unfortunately.
Seconded, Thirded, and Fourthed(?) Seriously dev. Shut this down and try again without failing to try and jump through loopholes so you can call this project something that it's not. |
|
|
|
If that's the case then you royally screwed up your PoS system because it's directly competing with PoW and blowing them out of the water.
we do not intend to keep this coin as pow, this is going to be pure pos soon So for now you have. 1. YOUR already staking 2000000 MGN. (about 100+ coins by POS block) 2. YOUR working masternodes. 3. YOUR mined 1400+ POW blocks. Community have. 1. No POW mining. 2. No staking. 3. Can buy you coins for 1000 sat for 1 coin. Good job. 1. We are not staking 2 million MGN. The main pre-mine wallet has been disabled for pos. In actual fact we are staking a fraction of coins from secondary wallets. The staking is done to strengthen the network. Read the ANN and you can see that any coins gained from the pre-mine will be burnt once the network is strong enough. 2. All of the rewards from developer masternodes are getting burnt.The only reason they are running is to create network stability. Read the ANN. 3. The coin is not supposed to be mined. The 70/30 split was put in place to discourage people from mining. 4. People can stake, so I don't know what you're talking about. 5. 1000 satoshi is a very modest price. Under $200k market cap, which is considerably lower than other coins offering similar features. So basically you just added a PoW phase that doesn't actually provide miners with any legitimate rewards so you don't have to technically call it an ICO? |
|
|
|
I minig a solo on Radeon Vega 56 and you are all losers  Congrats |
|
|
|
Waiting for first block from pool. After it we will take a look for nethash and diff. If this is POW diff and nethsh, it will rise. If they will get block too many time, diff 900+ is POW. Everything is easy, isn't it?
Well, the pool had about 2GH and it was showing 37 minutes to find a block and now the pool is down to 923 MH and it shows 67 minutes to find a block. Good job Dev your coin is DOA or should I say DOL (dead on launch) I think many are assuming the devs have a super strong mining rig, making it impossible for others to mine. The reality is that the 70/30 split is in place to deincentivise pow. You haven't incentivized anything other than paying you to obtain a suitable amount of coins. PoW is showing minuscule rewards provided they stay long enough to actually find a block. What you have here is an ICO scam in a fair launch costume. |
|
|
|
|
Anybody have 75Gh/s I can borrow so I can get 10 of these bad boys?
|
|
|
|
If that's the case then you royally screwed up your PoS system because it's directly competing with PoW and blowing them out of the water.
we do not intend to keep this coin as pow, this is going to be pure pos soon You've effectively made it PoS/MN where the only way to accumulate a sufficient amount of coins is by purchasing them directly from you. Also, I hope you know that saying it's not an ICO doesn't make it not an ICO. For reference: "In an ICO campaign, a percentage of the cryptocurrency is sold to early backers of the project in exchange for legal tender or other cryptocurrencies" You may want to go back and relabel this post before a moderator removes it. |
|
|
|
for those who are actually willing to read, this is working on pos now, there is no private pool and miner,
here is the proof
2017-11-23 00:01:52 CreateNewBlock(): total size 1000
2017-11-23 00:01:52 CPUMiner : proof-of-stake block found bb86d085f7832996e36bbb 72560ec12266b42524f01cacb8440a4e262bfe9510
2017-11-23 00:01:52 CPUMiner : proof-of-stake block was signed bb86d085f7832996e 36bbb72560ec12266b42524f01cacb8440a4e262bfe9510
2017-11-23 00:01:52 CBlock(hash=bb86d085f7832996e36bbb72560ec12266b42524f01cacb8 440a4e262bfe9510, ver=3, hashPrevBlock=0000000000196ce4c8578ab901bec9e6dd3247448 018fdcb0b607afb419f1149, hashMerkleRoot=ef3639c5d3cf89c509742706d5aaf43e36cd8e0d 29c3458439560f70014f7620, nTime=1511395342, nBits=1b2dc7c7, nNonce=0, vtx=2)
CTransaction(hash=1120d93a8b, ver=1, vin.size=1, vout.size=1, nLockTime=0)
CTxIn(COutPoint(000000000000000000000000000000000000000000000000000000000000 0000, 4294967295), coinbase 025b0b0101)
CTxOut(nValue=0.00000000, scriptPubKey=)
CTransaction(hash=7a2233063a, ver=1, vin.size=1, vout.size=3, nLockTime=0)
CTxIn(COutPoint(05fb94625abe30da1f81b0c5e89d9602d31049ae82b45cf40f033f3375c4 0200, 1), scriptSig=30450221008415d0a96a08a5)
CTxOut(nValue=0.00000000, scriptPubKey=)
CTxOut(nValue=19.89792000, scriptPubKey=02ad70bf00191dfad0b973892300e6)
CTxOut(nValue=9.80000000, scriptPubKey=OP_DUP OP_HASH160 3bf784a03976)
vMerkleTree: 1120d93a8b35deffa96b6dcb25493815b574ff0f55c8e86edbdcc0f63dda0110 7a2233063a7508f9508073b543650eb480e655822d256f03be7919bd4b0b0d11 ef3639c5d3cf89 c509742706d5aaf43e36cd8e0d29c3458439560f70014f7620
If that's the case then you royally screwed up your PoS system because it's directly competing with PoW and blowing them out of the water. |
|
|
|
Don't waste your time or hash power on this. Nothing against the pool operator but the project is pretty obviously a scam and not worth your recognition. |
|
|
|
|
Show Posts
