Anybody had an issue with fuses going bad? I had one melt on cube this morning. I took it apart, cleaned everything out, and then re-assembled it. Everything is working fine now.
I had two separate fuses melt/blow ( 2 separate cubes) after running 24 hours. Replaced them and have not had any more issues. Might just be cheap fuses they were shipped with. Someone also pointed out the PS may not be putting out enough volts so more current is being pulled so you can check the voltage with a volt meter. I am now running three machines on one PS and haven't had any issues for 2 weeks.
I got woken up at 5:30am this morning by the sound of my smoke detector going off in my bedroom and the horrible smell of burning plastic. I soon discovered that the fuse on one of my cubes had blown and partially melted. I cleaned it up and replaced the fuse, now that cube won't stay on high mode. I've disconnected and reconnected the 6pin cables and clicked update/restart a few times and it always reverts back to low. Any ideas to get it to stay on high?
Show Posts
