[DIY] - Reward $100 | Antminer S1/S3 Blade on Raspberry Pi

[pinhead666]

Here is simplified circuit of level shifter.This is close to that BM used.Caps are ceramic.

[Rekumkacz]

Hello.
After reading large amounts forum all the time I have a problem with running blades S1. I currently have Raspberry Pi with four converters UART with PL2303 chip.

I tried to change the PID and VID in usbutils.ci and 01-cgminer.rules but the blades are not recognized.
Do any of you can write a step -by-step with what parameters should compile cgminer .

[bartdp]

Hello,

Does someone has a idea how far you can drive ( voltage and frequence, resulting Watt/miner ) an S1 and a S3 ?
Power (electricity ) is no issue but noise is, so I would like to run then without 'forced' air ( = fans )
Would like to use them as 12 V electric convectors 

Rgds