Thanks to Willdono I finally received the swapped coins. Thanks.
Are there instructions to start the MN on Ubuntu 16 ?
Just a reprint from Telegram:####Start with Ubuntu 16.04
#### Search and replace <username> with your username for easier copy/paste
##Change root password
passwd
<Enter new root password>
adduser <username>
<follow prompts>
usermod -aG sudo <username>
su - <username>
sudo apt update
sudo apt upgrade -y
sudo apt-get install -y build-essential libtool autotools-dev autoconf pkg-config libssl-dev libboost-all-dev libzmq5 libevent-pthreads. git ufw nano
sudo add-apt-repository ppa:bitcoin/bitcoin
sudo apt-get update && sudo apt-get install -y libdb4.8-dev libdb4.8++-dev libminiupnpc-dev
##### If you need need a swap:
##### You NEED a swap if you only have 1G RAM
sudo fallocate -l 2G /swapfile
sudo chmod 600 /swapfile
sudo mkswap /swapfile
sudo swapon /swapfile
echo "/swapfile none swap sw 0 0" | sudo tee -a /etc/fstab
echo "vm.swappiness=10" | sudo tee -a /etc/sysctl.conf
git clone
https://github.com/SuB1X-Coin/zSub1xcd zSub1x
./autogen.sh
./configure
make
strip src/zsub1x{d,-cli,-tx}
cp src/zsub1x{d,-cli,-tx} ~
cd
mkdir .zsub1x
nano .zsub1x/zsub1x.conf
########## Paste and edit below into the file
rpcuser=<randomname>
rpcpassword=<randompassword>
rpcallowip=127.0.0.1
server=1
daemon=1
listen=1
port=5721
logtimestamps=1
maxconnections=256
masternode=1
externalip=<IP address of VPS>
masternodeprivkey=<masternode genkey results>
######### Save and exit
./zsub1xd -daemon
sudo ufw limit ssh
sudo ufw allow 5721
sudo ufw logging on
sudo ufw enable
crontab -e
####### Paste the following line at the bottom and save
@reboot ~/sub1xd -daemon
####### Note the following commands should work in Ubuntu but may not work in other distros
####### Some distros comment out these lines. Running both lines should work for either case.
####### Everyone should disable root SSH logins
sudo sed -i 's/#PermitRootLogin yes/PermitRootLogin no/' /etc/ssh/sshd_config
sudo sed -i 's/PermitRootLogin yes/PermitRootLogin no/' /etc/ssh/sshd_config
####### ONLY run this line if you have installed an SSH public key on the server
sudo sed -i 's/#PasswordAuthentication yes/#PasswordAuthentication no/' /etc/ssh/sshd_config
sudo sed -i 's/PasswordAuthentication yes/PasswordAuthentication no/' /etc/ssh/sshd_config
####### Enable the changes you just made to SSH daemon
sudo service sshd restart