[ANN][XC] >> Mandatory Update to new Wallet - The first POS X11 anonymous wallet

[r0ach]

My vote is for Xenucoin  

yea, that sounds solid....real...solid

[Ezravdb]

How about Xenographic Corosisative. (XC)

That name is easy to remember and catchy.

I lollled

[BitQuark]

In the X11Coin.Conf file should we set "gen=0" or "gen=1"

[atcsecure]

In the X11Coin.Conf file should we set "gen=0" or "gen=1"

no need for that entry

[BitQuark]

In the X11Coin.Conf file should we set "gen=0" or "gen=1"

no need for that entry

Ok thanks

[cryptohunter]

Could be a potential fork

to resolve


#1.  backup wallet.dat

#2.  Make sure you have backed up wallet.dat (see #1) & X11Coin.conf

#3.  clean out the roaming data in roaming\X11Coin

#4.  Copy wallet.dat and X11Coin.Conf back

#5.  Launch wallet with the correct parameters to sync to masternode
x11coin-qt.exe -addnode=162.243.109.24 -connect=162.243.109.24


This is download block chain from masternode and sync

Is this because not enough people started using the new wallet?

[provenceday]

X11 Multipool:  http://x11.ltc1btc.com/  which has more than 80G X11 hash rate.
Scrypt Multipool：http://www.ltc1btc.com/ which has more than 25G Scrypt hash rate.
So we are Professional on Multipool running

These pools look great, too bad they are Chinese though!

will have a English version soon.

[Pizpie]

http://www.reddit.com/r/XCofficialreddit/comments/26nfyi/dev_update/

IRC: http://webchat.freenode.net/?channels=#XCofficial

[provenceday]

Professional and Powerful XC Multipool Launched,
For X11 and Scrypt | Mine XC after POW ends

Edit：we are a team from china, so i am not a native English speaker, so if i make some mistake on this thread, hope you can understand this.


1   who we are?
We are a team from china, and we runned the two biggest chinese multipool more than 1 year.
X11 Multipool:  http://x11.ltc1btc.com/  which has more than 80G X11 hash rate.
Scrypt Multipool：http://www.ltc1btc.com/ which has more than 25G Scrypt hash rate.
So we are Professional on Multipool running.


2 how to mine at your pool?
Just as you mined on normal pool.
http://x11.ltc1btc.com/ For X11
http://www.ltc1btc.com/ For Scrypt
Just register the website, then start mine.
If you can not read the page, pls see the image tutorials in the last, or use translate.google.com , i will update the English version soon.

For X11:  x11bj.ltc1btc.com:8888   (Beijing Located server)
        or  x11gz.ltc1btc.com:8888  (Guangzhou Located server)
You can also use port:3333 or 7777
For Scrypt： bj.ltc1btc.com:8888
                 gz.ltc1btc.com:8888  
We will add American and European located Server soon


3 how to get my XC coin if i mined at your Multipool?
Now we still do not have the XC payment, will add this in 6 hours,
when you register our website, you can just leave your BTC Address now, and afte we add the XC payment, change your BTC address into XC address.


4 when will you pay me my mined XC?

We will pay your XC coin everday at GMT 0-4am We will pay you once per 24 hours.


5 Future development

We will have a independent website for Multipool in this week, but now the time is limited, you can mine at each of the two multipools. And we will add American and European Server in 2-3 days.

Everything is simple, just get some XC now

how to start mine, a simple English mining instruction:

[atcsecure]

Check the block # in your client, if it is different than http://cryptexplorer.com/chain/X11Coin then you are on the forked chain -- you need resync your wallet from the masternode

-addnode=162.243.109.24 -connect=162.243.109.24

this will force your wallet the correct chain


Backup up wallet.dat, delete everything in %appdata%\roaming\X11Coin\   


Then copy back wallet.dat to that folder


run wallet

x11coin-qt.exe -addnode=162.243.109.24 -connect=162.243.109.24

[cryptohunter]

Check the block # in your client, if it is different than http://cryptexplorer.com/chain/X11Coin then you are on the forked chain -- you need resync your wallet from the masternode

-addnode=162.243.109.24 -connect=162.243.109.24

this will force your wallet the correct chain


Backup up wallet.dat, delete everything in %appdata%\roaming\X11Coin\   


Then copy back wallet.dat to that folder


run wallet

x11coin-qt.exe -addnode=162.243.109.24 -connect=162.243.109.24

thanks,

we need to convey this to the exchanges

[tbearhere]

cryptoalts only 88% effective

Same here. 12-13% DOA is not acceptable.

Use different nodes! US East is a bit overloaded with hash right now (looks like one big farm on it), so get that spread to lower DOA. US West and US Central could take a fair amount of load off US East. Same with EU1, EU2, and SG1 - try to keep them balanced. Use the link below to see individual node stats.

I was once supporting somewhere between 1-2 GH/s for BlackCoin when BCPool was down getting DDoS for entire week, and things were fine. But hash rates were pretty well spread. It is especially important for smaller miners to use lower hash rate nodes. Other than that, because my pool is P2Pool based (the only multipool out there P2Pool based I believe, and thus hopefully DDoS resistant), so once the hash rates get high (over 150 MH/s on scrypt per node or 500 MH/s X11 per node) the difficulty on each node starts getting very high. This leads to high DOA rates unless you're the one contributing all of the hash!

http://cryptoalts.com/poolinfo/ to see individual node hash rates.

I wasn't expecting this much hash so I guess I should been very clear right from the start about keeping the hash spread - sorry! Anyway, worst case, you at least know where to set your failover mining addresses if you cannot obtain a low DOA rate.

Don't forget if you are interested to give hybrid mining a shot! http://cryptoalts.com/hybrid/

add your difficulty may be to high i think

[atcsecure]

Check the block # in your client, if it is different than http://cryptexplorer.com/chain/X11Coin then you are on the forked chain -- you need resync your wallet from the masternode

-addnode=162.243.109.24 -connect=162.243.109.24

this will force your wallet the correct chain


Backup up wallet.dat, delete everything in %appdata%\roaming\X11Coin\   


Then copy back wallet.dat to that folder


run wallet

x11coin-qt.exe -addnode=162.243.109.24 -connect=162.243.109.24

thanks,

we need to convey this to the exchanges

This is only for people who's block shown in wallet doesn't match what is shown on the block explorer

http://cryptexplorer.com/chain/X11Coin

Currently 21013

[tbearhere]

Use different nodes! US East is a bit overloaded with hash right now (looks like one big farm on it), so get that spread to lower DOA. US West and US Central could take a fair amount of load off US East. Same with EU1, EU2, and SG1 - try to keep them balanced. Use the link below to see individual node stats.

central no good  

[tbearhere]

5 mins for a yah

[tbearhere]

  anyone have a multipool for XC   ?

[provenceday]

your weight 67160

Network weight 11659

Expected time to earn reward is 15s

[provenceday]

  anyone have a multipool for XC   ?

https://bitcointalk.org/index.php?topic=627405.0

[evtrmm]

Check the block # in your client, if it is different than http://cryptexplorer.com/chain/X11Coin then you are on the forked chain -- you need resync your wallet from the masternode

-addnode=162.243.109.24 -connect=162.243.109.24

this will force your wallet the correct chain


Backup up wallet.dat, delete everything in %appdata%\roaming\X11Coin\   


Then copy back wallet.dat to that folder


run wallet

x11coin-qt.exe -addnode=162.243.109.24 -connect=162.243.109.24

^^Sometimes we forget that we are working with computer illiterate who are just here for the COIN.

Now are you still trying to implement the out of date wallet notification that would help alert/avoid this situation?

The reason I suggested this from the beginning is because with more and more people getting into Cryptos, the more NOOB friendly we should make it.  the everyday computer noob has no idea where even to look to see if their wallet is updated (or how to open a command prompt let alone execute a command).  If we want a currency for everyone, I suggest implementing this as another innovative feature that makes XC even more user friendly.

[tbearhere]

 anyone have a multipool for XC   ?

https://bitcointalk.org/index.php?topic=627405.0

no more china there rich enough   but thank you