New Shortened setup version:S3 WIFI setup including WWAN static IPs.The info Frotz provided helped and thanks!
I could not connect through my Verizon hot spot but I have it set to static IP so I think this is the problem
and will have to change it to DHCP when I have time and try it.
The S3 did connect to another wireless network.
I followed your instructions but reduced them and included my findings not that all may matter but it worked for me in the following sequence:
S3 WIFI SETUP:1- Starting from a factory-reset miner, log into it through Ethernet plugged directly from your computer to the miner.
Go to WAN and write down all the following addresses under your static IP of 192.168.1.99
Here is the list...
IPv4 netmask:
IPv4 gateway:
IPv4 broadcast:
Use custom DNS servers:
Once you have the above 4 addresses written down...
Go to Network->Wifi, Hit Search, find your Wireless Network/Cell Phone Wifi/Wifi Extender and connect with it.
Then go to Network->Interfaces-WWAN at the bottom and hit "Connect".
2- Even if LAN has DHCP hit apply and save anyway,
For me this generated a MAC address.
3- Go to WWAN and change DHCP to Static IP and enter the listed info above
list...
IPv4 netmask:
IPv4 gateway:
IPv4 broadcast:
Use custom DNS servers:
Hit Save and Apply.
Then go to WAN and change to DHCP
and you will begin mining.
Repeat the procedure for multiple miners with different WWAN static IPs.
Happy WIFI Mining!
MikeMike