hmmm my unit is in a cold bsmt 41c on 2 units and 27c and 32c on other two...the bsmt is 62F...i'm running .95 at 555gh stable (it drifts up 10-15gh and back down) and 547.7ave ...i'm doing like 537.7 stable on slush and I have the case open and 2 fans both 3" both in front right and left blowing crosswise (x pattern) across the miner

from posts here seems my unit works better then most...(or am I in denial) my impression ...and thus fence sitting on going to .98

also do the 'correct' error formula (not using knc cgminer hw errors alone) and I get a 5.5% or so error rate

the only other thing is once in a great while i'll have 1 core 4-86? enbable on and then off ..but prob only every 3hrs or so at most is my guess

so if your unit is ying my unit is yang

ying/yang

go figure..unless I'm missing something oh...my work unit is 7767.6 or some such....again it is stock miner .95 came in a destroyed box filled with rainwater ..I'm still going with the theory that the reason it works as well (or at all) is they had to hand carry the box/unit with 2 hands everywhere or it would have fallen thru the soggy box that was ripped in half...there fore it never "took flight" like I suspect other units did in such a large if light box....or I'm full of it..but anyway

whatever ...I usually walk by the unit and avert my eyes...I'm not worthy....its the boss

anywhoo....from where I see it right now correct me if I'm full of it (likely)

Searing

Nope, I have bertmod (with zpm fix) installed on mine and no problems.  Rock solid at 560-565GH/s.

i am getting a lot more duplicate shares for some reason, about 3 percent. not quite sure why.

My ASIC run better with casing, but the temp is quite high with casing on.
Is 70C Safe for my ASIC?
Thank You